Installation - Inalto IMC34BF User Manual

4l built-in convection microwave
Hide thumbs Also See for IMC34BF:
Table of Contents

Advertisement

Installation

INSTALLATION AND CONNECTION
This appliance is only intended for domestic use.
This microwave is intended for built-in use only.
It is not intended for counter-top use or for use inside
a cupboard.
Please observe the special installation instructions.
The appliance can be installed in a 60cm wide
wallmounted cupboard.
The appliance is fitted with a plug and must only be
connected to a properly installed earthed socket.
The mains voltage must correspond to the voltage
specified on the rating plate.
The socket must be installed and connecting cable
must only be replaced by a qualified electrician. If the
plug is no longer accessible following installation, an
all-pole disconnecting device must be present on the
installation side with a contact gap of at least 3mm.
Adapters, multi-way strips and extension leads must
not be used. Overloading can result in a risk of fire.
WARNING: The accessible surface
may be hot during operation.
INSTALLATION INSTRUCTIONS
Please read the manual carefully before installation
Screw
Trim-kit
Plastic Cover
NOTE: Electrical connection
The oven is fitted with a plug and must be only connected
to a properly installed earthed socket. In accordance
with the appropriate regulations, the socket must only be
installed and the connecting cable must only be replaced
by a qualified electrician.
If the plug is no longer accessible following installation and
all-pole isolating switch must be present on the installation
side with a contact gap of at least 3mm.
8

Advertisement

Table of Contents
loading

Table of Contents