Page 1
MAN-0009-A TM-GL User and Installation Guide EFFECTIVE 12.09.19 TM-GL Mobile Trans-Former Installation Guide and User Instructions Model: TM-GL Revision: December 2019 Reina Imaging 6107 W. Lou Ave., Crystal Lake, IL 60014 800-752-4918 www.reinaimaging.com...
• Failure to adhere to the Precautions listed herein may result in injury to user or patient! Compliance The TM-GL Mobile Trans-Former is a Class 1 Medical Device (510k exempt) in the USA and is registered to: Reina Imaging 6107 W. Lou Avenue...
TM-GL Installation and User Guide, December 2019 iii. Warranty Reina Imaging warrants to the Original Purchaser that this product will be free from defects in its workmanship and materials, under normal use and service conditions, as described herein. “Defects” as used in this warranty, is defined as any imperfections which impair the use of the product.
Imaging shall not be responsible for any liability caused by improper use. Reina Imaging assumes no responsibility to assess the user’s technical ability or clearance to operate the TM-GL Mobile Trans-Former. Use of the TM-GL Mobile Trans-Former constitutes the user’s acceptance of all responsibility for liability caused by its use.
2. Product Description and Specifications 2.1. Product Description - The TM-GL Mobile Trans-Former is designed to hold and position the D-EVO GL Long-Length DR Panel and an Anti-Scatter Grid for use in general radiography.
• Do not remove red safety screw near release pin in the right-side handle until instructed to do so in Section 5. • Failure to adhere to the Precautions listed above may result in injury to user! Reina Imaging 6107 W. Lou Ave., Crystal Lake, IL 60014 800-752-4918 www.reinaimaging.com Page 7 of 15...
5.2. Landscape Position - Rotate the Detector Mount anti-clockwise into the landscape position by holding the top and bottom and applying pressure until the unit rotates. It will automatically snap into the 90-degree detent. Reina Imaging 6107 W. Lou Ave., Crystal Lake, IL 60014 800-752-4918 www.reinaimaging.com Page 8 of 15...
Mounting the Grid Figure 5.4 5.5. Mock-up Grid – If the TM-GL is ordered without an Anti-scatter Grid, it will ship with a mock-up grid that simulates the weight and dimensions of the Anti- scatter Grid. The TM-GL is a mechanical device that requires a constant load in the Detector Mount to maintain a “zero gravity”...
Tightening the Tensioner Knobs Figure 5.6 5.7. Moving the TM-GL – Lower the Detector Mount to its lowermost position. Hold the frame from the rear near the top, place foot on bottom of frame and tilt the device back toward you. It will then be riding on the wheels.
The areas marked in yellow require additional force to be applied by the user to achieve positions near the limits of vertical travel. Height Adjustment Force Figure 6.1 Reina Imaging 6107 W. Lou Ave., Crystal Lake, IL 60014 800-752-4918 www.reinaimaging.com Page 12 of 15...
To turn back to portrait orientation, rotate the Detector Mount clockwise into the 0-degree detent. Rotating the D-EVO GL Panel Figure 6.3 Reina Imaging 6107 W. Lou Ave., Crystal Lake, IL 60014 800-752-4918 www.reinaimaging.com Page 13 of 15...
ALL QUESTIONS AND CONCERNS SHOULD BE FORWARDED TO: REINA IMAGING 6107 W. LOU AVE., CRYSTAL LAKE, IL 60014 800-752-4918 www.reinaimaging.com Changes to this document: 09.30.19 DRAFT Released DRAFT version Reina Imaging 6107 W. Lou Ave., Crystal Lake, IL 60014 800-752-4918 www.reinaimaging.com Page 15 of 15...
Need help?
Do you have a question about the TM-GL and is the answer not in the manual?
Questions and answers