Epson Stylus CX6500 Setup Manual

Setup
4049504-00
XXX
Cautions and Notes
c Cautions must be observed to avoid damage to your
equipment.
Notes contain important information and useful tips on the
operation of this product.
Unpacking
Make sure the following parts are included and not damaged.
power cord feeder guard
The body color and contents may vary in certain
locations.
ink
CD-ROM
cartridges
The power cord comes attached in some
countries.
Removing the Tapes
1. Open the scanner unit.
2. Remove all tape and packing material from this product. Make
sure the protective materials around the ink cartridges are
removed.
Do not Touch or remove.
Attaching the Parts
1. Attach the paper support.
2. Insert the feeder guard into two slots in front of the paper
support.
Note:
The feeder guard prevents items put on the document cover
from getting into the inside of this product.
paper support
Turning On
Plug in the power cord and press the P On button to turn on this
product.
Press
Note:
Do not connect it to your computer before step
fail to install the software.

Installing Ink Cartridges

1. Open the scanner unit.
2. Shake an ink cartridge four or five times and then remove it from
its package.
3. Open the cartridge cover.
4. Place each cartridge into its holder. Then, push the ink cartridge
down until it clicks into place.
Note:
Install all ink cartridges. This product does not work unless all
cartridges are installed properly.
5. Close the cartridge cover.
6. Lower the scanner unit.
Ink charging starts and it takes about two minutes to complete.
Initial charge... appears on the LCD panel and the Stylus CX
produces a variety of mechanical sounds. This is normal.
c Caution:
Never turn off this product during the ink charging
process.
Do not load paper until ink charging is complete.

Selecting a Language

or you will
1. Press the Setup button and
A button until 7.Languages
appears on the LCD panel
and then press the x Color
button.
2. Select a language by
pressing the D button.
3. Press the OK button.
Menu items appear in the selected language.
Do not touch

Loading Paper

1. Slide out the output extension tray.
2. Move the feeder guard towards you.
3. Slide out the edge guide.
4. Load a stack of paper to rest against the right side of the feeder
and slide the edge guide against the paper.
5. Move the feeder guard back.
Now you are ready to use this product as a stand-alone device.
See the next section to learn how to make a test copy. If you want
1 2
to install software, see "Connecting to Your Computer" on the
reverse side of this sheet.
A
D

Making Copies

3
1. Place a document on the document table.
Copyright© 2004 by Seiko Epson Corporation, Nagano, Japan.
Printed in xxxxxx xx.xx-xx