Dimplex DPRC41ECO-C Instruction Manual page 16

5. Sleep mode (this function can only be used with a remote control)
The sleep mode can be activated when in cool mode and heat mode.
• In cool mode:
After 1 hour the preset temperature is increased by 1
preset temperature will again be increased by 1
• In heat mode (Optional for Heating Function Unit only):
After 1 hour the preset temperature is decreased by 1
preset temperature will again be decreased by 1
The temperature will be kept constant for 10 hours and all the indicators will
dim to dark. The fan speed may switch over to low speed for silent operating
and cannot be adjusted.
TIMER SETTING (1-24 hours):
The timer has two methods of operation:
To turn off
(When power is on)
To turn on
(When power is off)
Cancel timer
Automatic Defrost
At low room temperatures, frost may build up at the evaporator during
operation. The unit will automatically start defrosting and the POWER LED will
blink. The defrost control sequence is as follows:
A. When the unit operates in the cooling operation or drying operation, and
the ambient temperature sensor senses the evaporator coil temperature
is below -1°C, then the compressor will stop operating for 10 minutes or
until the coil temperature reaches 7°C, then the unit will restart the cooling
operating mode.
B. When the unit operates in the heating operation or drying operation, and
the coil temperature sensor senses the temperature of the evaporator is
below 40°C and the differential temperature between coil temperature and
room temperature is below 19°C after the compressor has been operating
for 20 minutes, the unit will start defrosting for 5 minutes and the power
indicator will blink.
Overload Protection
In the event of power loss, to protect the compressor there is a 3-minute delay
before the compressor restarts.
16
15429_Dimplex DPRC41ECO-C Manual.indd 16 15429_Dimplex DPRC41ECO-C Manual.indd 16
C.
0
0
Press Timer key
to turn on the
timer function.
Press Timer key
to turn on the
timer function.
Press Up/Down repeatedly until the LED
shows '00'. Note: Pressing POWER will also
exit the timer setting.
C, after another hour the
0
C, after another hour the
0
C.
Press Up/Down
repeatedly to set the
power OFF timer.
Press Up/Down
repeatedly to set the
power ON timer.
7/09/20 4:24 PM 7/09/20 4:24 PM