Goodlife UltraSweep Traveler Instruction Manual

Goodlife UltraSweep Traveler Instruction Manual

Advertisement

UltraSweep
TM
Engine-mounted rodent repeller to protect parked vehicles
ULTRASWEEP
TRAVELER
TM
Protects
Cars, trucks, RVs, boats, small planes, ATVs, and other
parked vehicles.

Getting Started

Read entire manual before use
Before installation, ensure both the repeller and your vehicle engine are turned OFF
Mount the repeller so that the speaker is facing into the engine area
Never run wires along hot pipes or hoses
Use strong high-temperature double sided tape or the included cable ties for mounting
Do not let the wires sag; keep them secured with the included cable ties alongside existing wiring
Do not mount the device below the engine where it might be exposed to water
The UltraSweep
Traveler will work automatically when your engine stops, and will go into standby mode when the engine is
TM
running. It has two white flashing LEDs and one middle red/green LED that displays each power mode.
STANDBY MODE
When your engine is on, the repeller will automatically detect the vibration and go into a standby state. The red LED will flash
every 5 seconds to indicate standby mode.
WORKING MODE
Once the engine stops, the UltraSweep
repeller will run in Quiet Mode for 3 minutes. Then it will go into Super Mode for 80 seconds (if you have the optional LED strands
attached, they will flash every 5 seconds while the device is in Super Mode). The UltraSweep
between Quiet and Super Modes to prevent pests from adapting to the frequencies and flashing lights.

Safety Precautions

Keep away from children
Do not use near small animal pets such as rabbits
Do not place your ear next to the device
Do not open the device, or use it near water
Before powering the device "on", check cable-to-battery polarity (red to positive, black to negative)
Periodically confirm that the device and all wires are secure and not touching any hot pipes or hoses
Traveler
Instruction Manual

Included Parts

POWER CORD
WITH FUSE
Traveler will go into working mode. After 120 seconds the red LED will turn green. The
TM
4 CABLE TIES
Repels
Mice, rats, chipmunks, squirrels, and other small rodents.
Sold Separately
OPTIONAL
LED FLASHING LIGHTS
Traveler will continue to alternate
TM

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the UltraSweep Traveler and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Goodlife UltraSweep Traveler

  • Page 1 UltraSweep Traveler Instruction Manual Engine-mounted rodent repeller to protect parked vehicles Included Parts Sold Separately OPTIONAL POWER CORD 4 CABLE TIES ULTRASWEEP TRAVELER LED FLASHING LIGHTS WITH FUSE Protects Repels • • Cars, trucks, RVs, boats, small planes, ATVs, and other Mice, rats, chipmunks, squirrels, and other small rodents.
  • Page 2 UltraSweep Traveler Instruction Manual Installation 1 Ensure the repeller and your vehicle engine are OFF. This device uses a rocker switch: “–” for ON and “O” for OFF. 2 Run the black spade connector to the negative terminal of the battery and secure it. 3 Run the red spade connector to the positive battery terminal and secure that connection.

Table of Contents