RIDGID HD18000 Owner's Manual page 10

ASSEMBLY
Installing/Removing Cart Push
Handle
1. To Install Handle: Slide the Cart Push
Handle into the two Handle Holders
found on the rear of the Dust Drum.
2. Press down evenly on the Cart Push
Handle until both sides are fully seated
in the Handle Holders. The Release
Buttons should audibly snap into the
Locking Holes.
INSTALL:
3. To Remove Handle: Grasp both
sides of the Handle just above the
Handle Holders. Press in firmly on the
two Release Buttons using the index
fingers while pulling up on the Cart
Push Handle. It may help to place a
foot on one of the rear feet to secure
the Vac.
Cart Push Handle
Dust Drum
Release
Buttons (2)
Handle
Holders (2)
10
REMOVE:
Inserting/Removing the
Tug-A-Long Positive Locking
Hose with Dual-Flex
1. To Insert Hose: Locate the end of the
Tug-A-Long Positive Locking Hose with
Dual-Flex and align it with the Drum Inlet.
Position the Hose Release Button with
the Ridges on the Vac Inlet. Push the
Hose end straight into the Vac Inlet until
the Hose Release Button fully engages
the Inlet Ridges.
Hose Release Button
Tug-A-Long Positive
Locking Hose with Dual-Flex
Cart Push Handle
Release
Buttons (2)
Handle
Holders (2)
INSERT
HOSE
Drum
Inlet
Ridges