Adsl/g. lite 12-port access multiplexor module (13 pages)
Summary of Contents for Black Box EVSW-240-100-60
Page 1
B L A C K EVSW INSTALLATION MANUAL EVSW MANUEL D’INSTALLATION Electrical Load Management Device MAIN POWER SUPPLY MONITORED 240-208V / 120V, Single Phase - 100A ALIMENTATION PRINCIPALE 240-208V / 120V, Monophasé - 100A MAX POWER OF DEVICE CONTROLLED 240-208V, Single Phase - 50A Continuous Resistive Load 240-208V, Single Phase –...
The use of any trade names shown in this document is strictly forbidden. ABOUT THIS MANUAL In this document, the terms Black Box, Electrical Load Management Device Errors and inaccuracies and EVSW are equivalent. For any inaccuracy or omission, or to...
SAFETY INFORMATION This document describes important safety instructions which must be followed during installation, maintenance, and application of the device. Limited warranty Warning The installation of the device must be done in accordance with the latest electrical code – Traditional Electric Inc. warrants Read all instructions prior to using this product.
IENGLISHI average over 1 second. For other configurations, please contact the SPECIFICATIONS manufacturer. This device is a safety device with microcontroller that can protect an Power outage electrical distribution circuit in relation with its main breaker. It will prevent In the event of a power outage, the device automatically restores the power overloading the electrical distribution circuit by turning off the power to the supply to the vehicle charging station when power returns and the total charging station for the duration that the power demand exceeds 80% of...
STEP 3: INSTALLATION EVSW INSTALLATION 1. Remove the two cover screws and enclosure cover. STEP 1: CHECK THE PACKAGE CONTENTS EVSW-XXX-XXX-XX 2. Attach the device to the desired location. (Above main electrical panel). 1 x Controller & Enclosure 2 x 100 Amp CT 3.
IENGLISHI side of the contactor coil are secure. If these items all have been checked, STEP 4: TEST FOR OPERATION please contact the manufacturer. Test device for correct operation. Improper operation of contactor: MAINTENANCE Check if the CT leads are coiled close to other 120/240V lines and if so move Do not use any cleaning solvents on the devices.