Advertisement
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Rejuvenation CANBY TRESTLE TABLE
Summary of Contents for Rejuvenation CANBY TRESTLE TABLE
- Page 1 REJUVENATION CANBY TRESTLE TABLE – ASSEMBLY INSTRUCTIONS...
- Page 2 Step 1 – Prepare Parts & Tools Before getting started it is a good idea to read through these assembly instructions entirely and to collect the tools & hardware you need: Canby Trestle table top (boxed) Canby Trestle table legs (boxed) Hardware pack including: • 20 ea. 1” long, black, top‐mounting screws • 2 ea. ¼”‐20 x 3/8” truss‐head allen screws • 1 ea. 5/32” allen wrench A screw driver or, better yet, a drill driver.
- Page 3 Step 2 – Unpack Top Canby’s solid hardwood tops are heavy. We recommend that you have the help of a friend when handling them. Carefully unpack your top and set it face down on a clean carpeted surface. So as not to scratch or dent the top face – Please ensure the area in which you’re working is free from any debris.
- Page 4 Step 3 – Unpack & Position Table Legs Carefully unpack your Canby Trestle table legs. So as not to ding or scratch them please use care when removing them from the box. IMPORTANT ‐ Avoid using a knife to remove the bubble wrap and other packaging materials as there’s a greater risk of scratching the parts. As shown, place the legs at each end of the table top. Line up the pilot holes in the top with the mounting holes in the legs. If need be, the legs can be flexed open of closed a bit to get things to line IMPORTANT Slots facing to inside of table top. Insure that the slots on the bottom and at the center of each leg are facing the inside of the top.
- Page 5 Step 4 – Fasten Leg to Table Top With the holes lined up in Step 3, start a screw in each of the 8 holes at one end of the table. Do not fully tighten them yet.
- Page 6 Step 5 – Connect the Stretcher With one leg loosely attached, you can now connect a stretcher. Insert the threaded tab at one end of the stretcher into the slot in the leg. Using the supplied allen wrench thread one of the 3/8” long allen head screws through the bottom of the leg and into the tab. This screw can be tightened. Line up the holes in the mounting bracket at the other end of the stretcher with the matching pilot holes in the top. Install a 1” top‐mounting screw in each hole. Tighten the top‐mounting screws.
- Page 7 Step 6 – Connect 2 Leg & Stretcher Repeat steps 4 and 5 at the other end of the table. Once both legs and both stretchers are connected, go around and tighten all 16 of the top‐mounting screws.
- Page 8 Step 7 – Flipping the Table Upright Fully assembled, Canby Trestle tables are heavy. In order to avoid damage to the table or injury to yourself, you must have two people to flip the table over. With one of you at each end, start by tilting the table onto one of it’s long sides. Grasping both a leg and the edge of the table top, carefully lift the table fully off the ground, flip it upright, and place it gently on the floor… Enjoy!
Need help?
Do you have a question about the CANBY TRESTLE TABLE and is the answer not in the manual?
Questions and answers