Toshiba TWD-BK90S2H Owner's Manual page 14

INSTALLATION
Levelling the washing machine
Warning!
• Thelock nutson all four feet mustbescrewed tightlyagainstthehousing.
Check if the legs are closely attached to the cabinet. If not, please turn them to
1.
their original positions tighten the nuts.
2.Loosen the lock nut turn the feet until it closely contacts with the floor.
3.Adjust the legs and lock them with a spanner, make sure the machine is steady.
Connect Water Supply Hose
Warning!
• To prevent leakage or water damage, follow the instructions in this chapter
• Do not kink, crush, modify or sever water inlet hose.
Connect the inlet pipe as indicated, There are two ways to connect the inlet pipe.
1.Connection between ordinary tap and inlet hose.
clamp nut
Loosen clamp nut and
four bolts
2.Connection between screw tap and inlet hose.
Tap with threads and inlet hose
1
Raise
1
Press the tap end
tightly to the rubber
ring inside the clamp,
and then, tighten the
4 bolts
2
Lower
2
slide bushing
Press slide bushing,
insert inlet hose into
connecting base
Special tap for washing machine
13
3
Lock nut
foot
!
3
Connection finished
slide bushing
4
4