Non-observance of the safety instructions can result in a loss of all claims for indemnity. TDP058e.doc Rev. 29.09.2010 (v1.16) Page 4 / 33 Perrot REGNERBAU CALW GmbH Industriestraße 19-27 / D-75382 Althengstett / Germany Phone: 0049-7051-162-0 / Fax : 0049-7051-162–133 E-mail: perrot@perrot.de / E-mail Konstruktion : technik@perrot.de...
Description Control system components 2.1.1 Wireless Base Unit WBU (ZK28 93 684) Radio receiver for the wireless transmitter and interface for PERROT Greenkeeper. Without mounting parts like antenna, cable, etc. Green LED On solidly: Status OK Power connected and Yellow LED...
The display should now show ‘Charger Connect’. Checking whether a repeater unit is needed 3.5.1 Determine area with wireless connection After the WBU has been installed and the WT is ready for use, you can test out the area with wireless coverage. Note: Depending on terrain / location, you can assume a range of c.
Reach is determined by going to the ‘Transceiver Test’ menu (see 5.5.5) on the WT and pacing out the desired area. If the WT is moved quickly, e.g. in a moving vehicle, the wireless ATTENTION connection may get interrupted. With a good connection the test will show hardly any errors.
Transfering data to the base unit Transfer system data to base unit Before the WT can be used, the system data and associated decoder numbers have to be transferred to the base unit. This is generally done during installation and it is therefore usually not necessary to transfer the data again.
Transfer programme data to wireless transmitter As the WT can also be used to start watering programmes, the programme data must also be transferred from the WBU to the WT. This is done in a separate step, which is described at 5.5.2.