Oil Pressure Low Stop Engine; Automatic Transmission Only - Cadillac 2008 CTS Owner's Manual

Left Rear Door Open
This message displays when the driver side rear door is
not closed completely. Make sure that the door is
closed completely.
Maximum # Electronic Keys Learned
If your vehicle has the keyless access system, this
message displays when the maximum number of
transmitters have been learned. See Keyless Access
System Operation on page 2-9 for more information.

Oil Pressure Low Stop Engine

Notice: If you drive your vehicle while the engine
oil pressure is low, severe engine damage may
occur. If a low oil pressure warning appears on the
instrument panel cluster and/or DIC, stop the
vehicle as soon as possible. Do not drive the vehicle
until the cause of the low oil pressure is corrected.
See Engine Oil on page 5-16 for more information.
This message displays when the vehicle's engine
oil pressure is low. The oil pressure light may also
appear on the instrument panel cluster. See Oil
Pressure Light on page 3-43. See Engine Oil on
page 5-16 for more information.
Stop the vehicle immediately, as engine damage can
result from driving a vehicle with low oil pressure. Have
the vehicle serviced by your dealer/retailer as soon
as possible when this message is displayed.
Parking Assist Off
If your vehicle has the Ultrasonic Rear Parking Assist
(URPA) system, after the vehicle has been started, this
message displays to remind the driver that the URPA
system has been turned off. Press the set/reset button to
acknowledge this message and clear it from the DIC
display. To turn the URPA system back on, see "Parking
Assist" under DIC Operation and Displays on page 3-48.
See Ultrasonic Rear Parking Assist (URPA) on
page 2-51 for more information.
Passenger Door Open
This message displays when the passenger side front
door is not closed completely. Make sure that the door is
closed completely.
Press Brake To Start Engine

(Automatic Transmission Only)

If your vehicle has the keyless access system, this
message displays if you try to start the engine without
having the brake pressed. The brake needs to be
pressed when starting the engine. See Ignition Positions
(Key Access) on page 2-31 or Ignition Positions
(Keyless Access) on page 2-33 for more information.
3-61