Table of Contents
Advertisement
The A button indicator lamp flashes
and the programme settings appear in
the display panel.
Measure and add detergent
and care products
The washing machine doses your
detergent and fabric softener
automatically in most programmes.
The intelligent dosage has been preset
at the factory for all programmes in
which it can be used.
You can use these default settings or
change them. ~ Page 38
In addition to intelligent dosage,
cleaning aids (e.g. stain remover) can
be added manually to compartment
v u, if necessary. ~ Page 47
For programmes that cannot be used
with intelligent dosage, or if you would
prefer to dose manually (in which case
set intelligent dosage to "off" ö), add
detergent to compartment v u.
~ Page 47
Change the programme
default settings
You can use the default settings for
each washing cycle or change them.
To do this, repeatedly press the
corresponding button until the required
setting is displayed.
Pressing and holding the buttons
Note:
automatically runs through the setting
values until the last one. Then press the
button again and you will be able to
change the setting values again.
Operating the appliance
The settings are activated without
needing to be confirmed.
Notes
The i-DOS settings are saved until
■
they are changed again, even if the
washing machine is switched off.
Other programme settings are not
■
saved if the washing machine is
switched off.
Default programme settings
~ Page 37
Select additional programme
settings
By selecting additional settings, you can
better adapt the washing process to
your items of laundry.
The settings can be selected or
deselected depending on the
programme progress.
The button indicator lamps light up if a
setting is activated.
The settings are not saved after
switching off the washing machine.
Additional programme settings
~ Page 39
Start the programme
Press the A button. The indicator lamp
lights up and the programme starts.
The display panel shows the "Ready in"
time while the programme is running or
the programme length and the
programme progress symbols when the
washing programme has started.
Display panel ~ Page 27
Note:
Foam detection
If the Å symbol also lights up in the
display panel, the washing machine has
detected too much foam during the
wash programme and automatically
activated additional rinse cycles to
remove the foam.
en
41
Advertisement
Table of Contents
