Warner Electric CBC-150 Series Installation And Operation Manual

CBC-150 Series Clutch/Brake Controls
P-239-21-WE
819-0477
Introduction
The Warner Electric CBC-150 series is a family of clutch/
brake controls which conveniently mount to the conduit
box cover of the Electro Module line of electromagnetic
clutches and brakes. The CBC-150 series controls are
dual channel devices available in two models:
CBC-150-1
CBC-150-2
These controls are designed for operation of all Warner
Electric 90 VDC clutches and brakes. They should not,
however, be used to directly power Warner Electric
permanent magnet failsafe brakes as these products
require an adjustable current or voltage supply for
optimum release. These controls indicate when the
output channels are energized with LEDs
Suppression circuitry insures fast coil decay for
rapid cycle rates. Customer provided switching is
accomplished on the AC input to the control.
Specifications
Input
CBC-150-1: 120 VAC, 50/60 Hz, 1 phase, 200 VA max.
CBC-150-2: 220/240 VAC, 50/60 Hz, 1 phase, 200 VA max.
Output
CBC-150-1: 90 VDC full-wave rectified nominal,
Dual channel, 0.8A max. per channel.
CBC-150-2: 90 VDC half-wave rectified nominal,
Dual channel, 0.8A max. per channel.
Fusing (external to control, supplied by customer)
CBC-150-1: 2 amp, 125 V fast-blo
CBC-150-2: 2 amp, 250 V fast-blo; required on both legs.
Switching (Supplied by customer on AC input )
1. Electromechanical (SPDT) (or Two SPST)
CBC-150-1: Rated 120 VAC, 1 amp minimum
CBC-150-2: Rated 240 VAC, 1 amp minimum
2. Solid State (maximum leakage current < 2ma)
CBC-150-1: Rated 140 VAC, 2 amp minimum
CBC-150-2: Rated 280 VAC, 2 amp minimum
Ambient Temperature
-20° to +122°F (-29° to 50°C)
120 VAC input
220/240 VAC input
Installation and Operation Manual
Failure to follow these
instructions may result in product damage,
equipment damage, and serious or fatal injury to
personnel.
Reorder Information
Model
CBC-150-1
CBC-150-2
Conduit
Cycle Rate
In most applications, the maximum cycle rate is limited
by the clutch and/or brake capability rather than by
the control. To determine specific capabilities, consult
the Application Engineering section of Warner Electric
Catalogs, P-8586-WE, P-8587-WE, P-8588-WE,
P-8589-WE, P-8590-WE or P-1264-WE. The following
table lists those clutch/brake models which maximum
cycle rate may be limited by this control.
Models Limited by Control
PB/PC-500
SF-500, EP-500, PB-650, EB-650
SF-650, EC-650, EM-210
PB/PC-825, EB-825
SF-825, EP-825, PC-1000, EB-1000
SF-825 brg., EC-825, EC-1000
SF-1000, EP-1000, PB/PC-1225
SF-1225, PB/PC-1525, EB-1225, AT-205
SF-1525, EP-1525, EC-1225
SF-1525HT
Part Number
6004-448-001
6004-448-002
5370-101-042
Maximum Cycle
Rate
(cycles/min)
250
220
175
130
100
95
70
50
40
20