Sierra Flame AF-4000 Supreme Setup And User Manual

AF-4000 Supreme
Hand-Held Remote Control
Set-Up and User Guide

Initial Setup

Installation of (2) AAA-size batteries will activate the setup mode. Setup mode can also be
activated by pressing the FLAME REAR and PROG/TIME buttons simultaneously for 5 seconds.
The control will exit setup mode if no button is pressed for 20 seconds. Appropriate icon on LCD
will flash when ready for setup.
Press the UP or Down button in setup mode to change the temperature scale. Press SET button to
skip or advance to Fuel Type setup.
Press the UP or DOWN button to switch control from Natural to LP, or LP to Natural Gas. Press
SET button to skip or advance to Clock setup.
Press the UP or Down Button to set the hour. Press SET to advance to minutes.
Press the UP or Down button to set minutes. Press SET to advance to AM or PM.
Press the UP or Down button to set AM or PM. Press the SET button to advance to the day of
week.
Use UP or Down button to select the day of the week.
The control will exit setup mode in 20 seconds.

MODE Button

The MODE button cycles the unit through the basic operational modes.
When off, press and release the MODE button to turn the unit on in Manual mode.
Press and release the MODE button again, and the unit will operate in the Thermostat mode.
Press and release the MODE button again, and the unit will turn off.

Program Mode

The Program function is controlled by the PROG/TIME button. The control may be programmed
for up to two settings for weekdays and two settings for weekends. The control is preset to
factory settings.
When the Program Mode is activated, the unit will automatically be operating in the Thermostat
Mode. The unit will turn on or off based upon room and set temperature.