Scheduling The Washing Time - Beko DEN48520W User Manual

Floor illumination is activated
automatically when the washing
programme starts and remains lit until
the end of the programme.
Floor illumination cannot be cancelled
by the user.
SelfDry
(Depends on the Model)
Thanks to the "SelfDry" feature on your
machine, the drying effectiveness of your
machine is improved and power is saved.
There are two options, namely "OFF" and
"ON".
You may use sub-menu settings to change
"SelfDry" settings.
When you activate this function, the door
of your machine is opened automatically at
the end of the washing cycle.
SelfDry feature opens the door at
the end of the washing cycle thanks
to the "door opening shafts". This
process takes about 2 minutes. Do not
force to close the door if the power is
interrupted while the shafts are moving
out. Operation shall be completed
and shafts shall be retracted when the
power is restored.
SelfDry function may cause changes to
the cycle time.

Scheduling the washing time

Time Delay
If an economical electricity tariff is applied
in your region, you can use the Time
Delay function to wash your dishes during
appropriate hours.
You can delay the start of the selected
programme until 24 hours.
1. Press the Time Delay function key after
selecting the washing programme and
other auxiliary functions.
2. Once you press the Time Delay key,
Display Information Line will show
"0:30" and Time Delay indicator will
start flashing.
3. Set the desired time by pressing the
Time Delay key. Time will increase with
increments of 30 minutes up to 6 hours
and after that in 1 hour increments up
to 24 hours every time you press the
key.
4. Close the door of your machine after
setting the Delayed Start. Once
the delay time is over, the selected
programme will start automatically.
Changing the settings while Time
Delay function is active
While the Time Delay function is activated,
you cannot make changes in the washing
programme, auxiliary functions or the
duration of delay time.
Programme and auxiliary functions
cannot be set/changed after the
programme has started.
To cancel the Time Delay function
Open the door of the product Press
and hold the Programme Selection /
Programme Cancel keys for 3 seconds.
After the 3 - 2 - 1 countdown, 0:01 is
displayed, close the door of the product
and wait for the draining process complete.
Draining is completed in 2 minutes and the
machine gives an audible warning when it
is completed.
35/EN