Advertisement
Brief Introduction
GA6012 is a new member of a family of professional charger in our
company. It represents today's new technology for lead-acid type battery
charging. Programmed four auto stages (
charge-trickle-pulse
maintenance) charging process，It is designed for all
kinds of 12V 4~100Ah lead-acid battery, such as SLA, AGM and Gel battery.
Charging instructions：
Connect battery to detect voltage firstly. When battery voltage is less
than 11V, it enters pre-charge mode. Half an hour later, if the voltage is still
below 11V, it enters the repair mode(Repair). (Repair time is 24H, if 24H later
the battery voltage is still less than 11V, It is recommended to replace the
battery, if it is higher than 11V, enter the main charging mode); When
charging current is less than 0.5 A, it enters trickle, (at this time percentage
bar display 100 %, and charge full(FUL) display). When trickle current is less
than 200mA, charger will cutoff completely. After charging cut off, the
battery voltage is detected every 2H. If the voltage is less than 13V, charger
ry to recharge.
will pulse the batte
Specification：
100-240VAC，50-60Hz
Input Voltage
Input Current
1.1A
Rating 12V，Bulk 14.4V/14.7V（14.7V for low
Voltage
Charge
temperature）
4.2A max
Current
Charge
Battery type
All typesof12Vlead-acidbatteries.( SLA,Gel, AGM....)
Size
120X67X41（L*W*H）
Weight
285g
Enclosure
Naturalconvection. Do not cover the charger.
Pre-charge, repair or normal
max
Charging display panel
Voltage, current, temperature
Ambient temperature
Pulse desulfation
Percentage bar
Battery Access
Simple exception handling
Not bright
flicker
YY
flicker
ERR
：
Power off
Battery not connected
Reverse, circuit short, or bad battery
Advertisement
