Advertisement
ASSEMBLY INSTRUCTIONS
FIGURE 1
Place the Handle (A) onto the Support Frame (B)
connector. Make sure that the reel shaft is facing toward
the inside. Push down firmly until Handle (A) is seated
against Support Frame (B). Repeat for the opposite side.
FIGURE 2
Fasten Handle (A) to Support Frame (B) using the 1/4-20 x
1 1/4" Carriage Bolts (C), 1/4" x 1/2" Flat Washers (D), and
1/4 x 20 Nylon-Insert Locknuts (E). Repeat for the opposite
side.
FIGURE 3
Load wire spools onto Reel Shafts and secure using Hitch
Pin Clips (F). Load spools from the inside out. For best
results, when using multiple spools, balance the load
equally on both sides.
Madison Electric Products, Inc
.
26401 Fargo Avenue • Bedford Heights, OH 44146 • P: 1-800-631-7775 • F: 1-216-391-7912
Handle (A)
Frame
Connector
Reel
Shaft
Support Frame (B)
Washers (D)
Lock Nuts
Top View
Reel Shafts
Push
Down
FIGURE 1
Carriage
Bolts (C)
Handle (A)
Reel Shaft
Support Frame (B)
FIGURE 2
Hitch Pin
Wire
Clip (F)
Spool
FIGURE 3
© 2015/02032
Advertisement
