Connecting The Drain Hose To The Drain; Adjusting The Feet - Beko B5W51041AW User Manual

4.1.5 Connecting the drain hose to the drain

• Attach the end of the drain hose directly to waste water drain, washbasin or bathtub.
A
Your house will be flooded if the drain hose is dislocated during water draining. There is also a risk of burning due to the
high washing temperatures! In order to prevent such situations and make sure that the product performs water intake and
drain processes without any problem, fix the drain hose securely.
• Connect the drain hose to a minimum height of 40 cm and a maximum height of 100 cm.
• In case the drain hose is elevated after laying it on the floor level or close to the ground (less than 40 cm
above the ground), water draining becomes more difficult and the laundry may come out excessively wet.
Thus, follow the heights provided in the figure.
• To prevent the waste water to go back into the product again and to ensure easy drainage, do not immerse
the end of the hose into the waste water or do not insert it into the drain for more than 15 cm. If it is too
long, cut it short.
• The end of the hose should not be bent, it should not be stepped on and the hose must not be pinched
between the drain and the product. Otherwise, water discharge issues may emerge.
• If the length of the hose is too short, use it by adding an original extension hose. The length of the hose
shall not be longer than 3.2 m. To prevent water leaks, always secure the connection between the extension
hose and the drain hose of the product with a suitable clamp so that it does not come off and cause leaks.

4.1.6 Adjusting the feet

In order to ensure that the product operates more silently and vibration-free, it must stand level and balanced on its feet.
Ensure that the product is balanced by adjusting the feet. Otherwise, the product may move from its place and cause
WARNING
crushing, noise and vibration problems.
Do not use any tools to loosen the lock nuts. Otherwise, they will get damaged.
1 Loosen the lock nuts on the feet by hand.
2 Adjust the feet until the product stands level and balanced.
3 Tighten all lock nuts again by hand.
12 / EN
Washing Machine / User Manual