Table of Contents
Advertisement
Quick Links
§
Please make sure of the following before starting to use this software.
1. Please make sure that Java software provided by Sun Microsystems is installed
in your PC. If not, please install according to the following instructions.
i. Go to http://java.sun.com/j2se/1.4.2_04/download.html
ii. Download J2SE v 1.4.2_04 (JRE)
iii. Run the install package on your PC.
NOTE: This remote program is not compatible with the Java provided by
Microsoft! This remote program is compatible only with Windows 98/2000/XP
§
Start up
1. Power on the EDR-X1, and wait until the LED is illuminated after flashing.
2. Setup the network on the EDR-X1 at the MENU screen. Check the accessibility
by pinging the EDR-X1.
3. Make sure there is recorded data in the hard disk of the EDR-X1. This program
does not work if there is no recorded data in the hard disk.
4. Double click "edr-x1prog. jar". You can make a short cut to "edr-x1prog. jar" on
your desktop. Click "AGREE" on the Remote Software Agreement screen.
5. Input the IP address of the EDR-X1, then click "REGISTER" to make the IP
address registered. If the IP address is already registered, you can skip this
article 5.
6. Choose the IP address you need to access and click "CONNECT". If the
connection was not successfully made, an error message such as "Network
Error" or "Command Error" appears on the screen. 'Check your DVR if one of
these error message appears.
§
Features
CURRENT MODE
1-1 POWER ON MODE:
One of the following modes currently selected is displayed.
Normal
Auto
Power off
1-2 REWRITE MODE:
One of the following modes currently selected is displayed.
Ring off
On
Only Internal Disk
EDR-X1 SAMPLE PROGRAM
32-bit/64-bit for Windows/Linux/Solaris SPARC
32-bit for Solaris x86
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Elmo EDR-X1
Summary of Contents for Elmo EDR-X1
- Page 1 2. Setup the network on the EDR-X1 at the MENU screen. Check the accessibility by pinging the EDR-X1. 3. Make sure there is recorded data in the hard disk of the EDR-X1. This program does not work if there is no recorded data in the hard disk.
- Page 2 1-3 PLAY BACK MODE: One of the following modes currently selected is displayed. Removable Disk Internal Disk PLAY BACK 2-1 << KEY Reverse Playback from the Playback position with the skip time interval. Click STOP to stop playback. Note: If no image data is recorded before the playback position, this function cannot be performed.
- Page 3 If it can be connected to by pinging, go to NETWORK CONNECT screen and reconnect. Measure DVR stop operation Cause 1. Transmission error to DVR 2. EDR is not in normal condition (Power LED on), or recorded data was deleted by disc formatting, during connection. Measure Check the EDR and reconnect Note: If no image data is recorded before the playback position, this function cannot be performed.
- Page 4 ELMO will not warrant the performance or result you may obtain by using this software with your network. -- Only one PC can control this program. If another PC accessed to the EDR-X1 while your PC is connected to it, your connection will be terminated.
Need help?
Do you have a question about the EDR-X1 and is the answer not in the manual?
Questions and answers