Table of Contents
Advertisement
Quick Links
PROFESSIONAL
18 INCH ROTARY SURFACE CLEANER
AW-7020-8000
OPERATING INSTRUCTIONS AND
PARTS LIST
CAUTION
RISK OF INJURY! READ MANUAL BEFORE OPERATING!
THIS MANUAL IS AN IMPORTANT PART OF THE CLEANER AND MUST
REMAIN WITH THE UNIT WHEN YOU SELL OR RENT IT!
Rotary Surface Cleaner Manual (18 Inch) 2000
1
Copyright 2000, Mi-T-M Corporation
37-0423-072718
©
Advertisement
Table of Contents
Related Manuals for Mi-T-M AW-7020-8000
Summary of Contents for Mi-T-M AW-7020-8000
- Page 1 RISK OF INJURY! READ MANUAL BEFORE OPERATING! THIS MANUAL IS AN IMPORTANT PART OF THE CLEANER AND MUST REMAIN WITH THE UNIT WHEN YOU SELL OR RENT IT! Rotary Surface Cleaner Manual (18 Inch) 2000 Copyright 2000, Mi-T-M Corporation 37-0423-072718 ©...
-
Page 2: Table Of Contents
TABLE OF CONTENTS INTRODUCTION ..................3 SPECIFICATIONS .................. 4 IMPORTANT SAFETY WARNINGS ............5-7 RISK OF INJECTION OR SEVERE CUTTING INJURY ....5 RISK OF BURNS ................6 RISK OF BODILY INJURY ............. 6-7 FEATURES ..................... 8 INSTALLATION & PREPARATION ............9-10 NOZZLE SELECTION &... -
Page 3: Introduction
INTRODUCTION Congratulations on the purchase of your new Mi-T-M Rotary Surface Cleaner! You can be assured this Cleaner was constructed and designed with quality and performance in mind. Each component has been rigorously tested to ensure the highest level of acceptance. -
Page 4: Specifications
SPECIFICATIONS Operating Pressure (PSI/ BAR) 2000-4000/ 138-276 Water Volume (GPM/ IPM) 3.0-10.0/ 11.36- 37.85 Maximum Temperature (°F/ °C) 212°/ 100° Maximum RPM 2500 Unit Net Weight (lbs./ Kg) 19/ 8.62 Unit Net Dimensions (IN/ CM) L18.75 x W18.75 x H71.25/ L47.6 x W47.6 x H181.0 Unit Shipping Weight (Ibs./ Kg) 25/ 11.34... -
Page 5: Important Safety Warnings
SAFETY WARNINGS When using this product, basic precautions should always be observed, including the following: READ ALL SAFETY WARNINGS BEFORE USING ROTARY SURFACE CLEANER POTENTIAL PREVENTION HAZARD CONSEQUENCE Serious injury or death could Keep clear of nozzle and spray! Never RISK OF INJECTION occur from high pressure put your hand, fingers or body directly... -
Page 6: Risk Of Burns
SAFETY WARNINGS READ ALL SAFETY WARNINGS BEFORE USING ROTARY SURFACE CLEANER POTENTIAL PREVENTION HAZARD CONSEQUENCE The Rotary Surface Cleaner is RISK OF BURNS Serious injury may occur capable of accepting a maximum of from touching Hot Surfaces. 212°F. When using in a hot water application, do not touch or direct discharge stream at persons. - Page 7 SAFETY WARNINGS READ ALL SAFETY WARNINGS BEFORE USING ROTARY SURFACE CLEANER POTENTIAL HAZARD PREVENTION CONSEQUENCE RISK OF BODILY Injury may occur from the ALWAYS hold on firmly to the handles rotary surface cleaner. INJURY of the Rotary Surface Cleaner when operating the unit.
-
Page 8: Features
FEATURES 1. Box. 2. Insert. 3. Insert. 4. Cover Assembly. 5. Clevis Pin. 6. Bridge Pin. 7. Handle-Lower. 8. Clevis Pin. 9. Handle-Upper. Rotary Surface Cleaner Manual (18 Inch) 2000... -
Page 9: Installation & Preparation
INSTALLATION & PREPARATION NOZZLE SELECTION & INSTALLATION: Your Rotary Surface Cleaner will come installed with one set of 2502.5 nozzles. a. The minimum orifice size to be used in your Rotary Surface Cleaner is half that which is being used in your pressure washer. Example: If your pressure washer uses a size 5 orifice, you will need to use a size 2.5 orifice in your Rotary Surface Cleaner. -
Page 10: Pre-Start Inspection Procedures
INSTALLATION & PREPARATION PRE-START INSPECTION PROCEDURES: Inspect Rotary Surface Cleaner before each use. Tighten rotating bar, bolts and fittings as needed. Ensure all connections are secure. Turn the water supply completely "ON". (DO NOT START PRESSURE WASHER!) Inspect hoses for kinking, cut or leaks. If found, DO NOT USE HOSE! Replace damaged hoses before starting. - Page 11 WARNING THE FOLLOWING CONTAINS OPERATING AND MAINTENANCE INSTRUCTIONS. DO NOT ATTEMPT TO OPERATE THIS ROTARY SURFACE CLEANER UNTIL YOU HAVE READ AND UNDERSTOOD ALL SAFETY WARNING AND INSTRUCTIONS LISTED IN THIS MANUAL. INCORRECT OPERATION OF THIS UNIT CAN CAUSE SERIOUS INJURY!! DO NOT ALTER OR MODIFY THIS EQUIPMENT IN ANY MANNER! Rotary Surface Cleaner Manual (18 Inch) 2000...
-
Page 12: Operation
OPERATION START-UP: Lock the trigger gun on the Rotary Surface Cleaner in the "OFF" position (move the lever on the gun handle to a 90° angle so it rests against the handle grip). Ensure all connections are secure. Unlock the trigger gun and squeeze the trigger while starting the Pressure Washer. -
Page 13: Troubleshooting
TROUBLESHOOTING PROBLEM PROBABLE CAUSE REMEDY Inadequate cleaning power. Not enough PSI from Ensure unit produces a minimum pressure washer. 2000 PSI. Most effective cleaning range is 2500-4000 PSI. Inadequate water supply. Turn water supply completely "ON" and/ or clean water filter on pressure washer. -
Page 14: Parts List
18 INCH ROTARY SURFACE CLEANER AW-7020-8000 Rotary Surface Cleaner Manual (18 Inch) 2000... - Page 15 AW-7020-8000 083017 JRC 18 INCH ROTARY SURFACE CLEANER REF. # DESCRIPTION PART # QTY. Screw 27-8911 Spray Nozzle- 1501.5 18-0294 Spray Nozzle- 1502 18-0295 Spray Nozzle- 1502.5 18-0296 Spray Nozzle- 1503 18-0053 Spray Nozzle- 2501.5 18-0297 Spray Nozzle- 2502 18-0298 Spray Nozzle- 2502.5...
- Page 16 SWIVEL ASSEMBLY (33-0289) Rotary Surface Cleaner Manual (18 Inch) 2000...
- Page 17 33-0289 061213 RAG SWIVEL ASSEMBLY ITEM DESCRIPTION Mi-T-M # LOCKNUT 30-0136 QUAD SEAL (SEE KIT 70-0218) SEE KIT BEARING HOUSING 33-0285 SNAP RING 43-0094 ROTOR SHAFT 33-0284 BEARING 48-0068 LOWER PLATE 33-0283 STATIC O-RING (SEE KIT 70-0218) SEE KIT SECONDARY SEAL...
- Page 18 NOTES Rotary Surface Cleaner Manual (18 Inch) 2000...
-
Page 19: Warranty
STATEMENT OF WARRANTY FOR YOUR ROTARY SURFACE CLEANER Mi-T-M warrants all parts, (except those referred to below), of your Rotary Surface Cleaner to be free from defects in materials and workmanship during the following periods: For One (1) Year from the date of original purchase:... - Page 20 Rotary Surface Cleaner Manual (18 Inch) 2000...
Need help?
Do you have a question about the AW-7020-8000 and is the answer not in the manual?
Questions and answers