Advertisement
TROUBLESHOOTING (continued)
Symptom
Output pressure varies high and low.
No detergent.
Garden hose connection leaks.
Spray wand, or extension, or nozzle leaks. Spray nozzle not properly attached.
Pump is noisy.
Water leaks from pump (up to 10 drops per
minute is permissible).
Oil Drips.
Motor buzzes but fails to run.
IF YOU ENCOUNTER ANY ADDITIONAL DIFFICULTIES NOT LISTED, CALL CUSTOMER SERVICE AT
16 of 18
Cause
Not enough inlet water supply.
Pump is sucking air.
Water inlet filter is clogged.
Discharge nozzle is obstructed.
Calcified gun, hose or spray wand.
Detergent suction tube not properly connected to
the machine.
Detergent is too thick.
Filter on detergent suction tube is clogged.
Damaged or clogged detergent suction tube.
Spray wand is in high pressure position.
Discharge nozzle is obstructed.
Loose fittings.
Missing/worn rubber washer.
Broken o-ring or plastic insert.
Pump is sucking air.
Loose fittings.
Water seals are damaged or worn.
Oil seals are damaged or worn.
Supply voltage below minimum.
System has residual pressure.
Voltage loss due to extension cord.
Pressure washer not used for long periods
[1] 919-550-3221 FOR ASSISTANCE.
®
BEAST Electric Pressure Washers
Solution
Turn water on full force. Check garden hose for kinks,
leaks or blockage.
Check that hoses and fittings are air tight. Turn off ma-
chine. Purge pump by squeezing trigger gun until a
steady flow of water emerges through the nozzle.
Remove filter and rinse out in warm water.
Blow out or remove debris with a fine needle.
Run distilled vinegar through detergent suction tube.
Check connection.
Dilute detergent, for best results use recommended
detergent.
Run warm water through filter to remove debris.
Remove obstruction or replace detergent suction tube.
Turn spray wand tip to low pressure position.
Blow out or remove
Tighten fittings.
Insert new washer.
Insert the spray nozzle into the trigger Carefully press in
against the spring tension and twist into the locked
position.
Call Customer Support
Check that hoses and fittings are air tight. Turn off
machine and purge pump by squeezing trigger gun until a
steady flow of water emerges through the nozzle.
Check that all fittings are tight.
Call Customer Support
Call Customer Support
Verify that only the pressure washer is running on this
circuit.
Turn unit "OFF", squeeze trigger on spray want to release
pressure, then turn unit "ON".
Do not use extension cord with this unit—plug directly
into power outlet.
Call Customer Service.
Rev: April 2015
Advertisement
