Connecting With A Hdmi To Dvi Cable - LG 26LG4000 Owner's Manual

Connecting with a HDMI to DVI cable

1 Connect the DVI output of the PC to the H H D D M M I I / / D D V V I I I I N N
1 1 ( ( D D V V I I ) ) jack on the TV.
Connect the PC audio output to the A A U U D D I I O O I I N N
2
( ( R R G G B B / / D D V V I I ) ) jack on the TV.
Turn on the PC and the TV.
3
Select HDMI 1 input source using the I I N N P P U U T T button
4
on the remote control.
!
NOTE
To enjoy vivid picture and sound, connect a PC to
G
the TV.
Avoid keeping a fixed image on the TV's screen for
G
prolonged periods of time. The fixed image may
become permanently imprinted on the screen; use
a screen saver when possible.
Connect the PC to the RGB (PC) or HDMI IN (or
G
HDMI/DVI IN) port of the TV; change the
resolution.
There may be interference relating to resolution,
G
vertical pattern, contrast or brightness in PC
mode. Change the PC mode to another resolution
or change the refresh rate to another rate or
adjust the brightness and contrast on the menu
until the picture is clear. If the refresh rate of the
PC graphic card can not be changed, change the
PC graphic card or consult the manufacturer of
the PC graphic card.
The synchronization
G
Horizontal and Vertical frequencies are separate.
Connect the signal cable from the monitor output
G
port of the PC to the RGB (PC) port of the TV or
the signal cable from the HDMI output port of the
PC to the HDMI IN (or HDMI/DVI IN) port on the
TV.
input waveform for
USB IN
SERVICE ONLY
HDMI/DVI IN
2
1(DVI)
1
DVI-PC OUTPUT
Connect the audio cable from the PC to the Audio
G
input on the TV. (Audio cables are not included
with the TV).
If using a sound card, adjust PC sound as required.
G
This TV uses a VESA Plug and Play Solution. The
G
TV provides EDID data to the PC system with a
DDC protocol. The PC adjusts automatically when
using this TV.
DDC protocol is preset for RGB (Analog RGB),
G
HDMI (Digital RGB) mode.
If required, adjust the settings for Plug and Play
G
functionality.
If the graphic card on the PC does not output
G
analogue and digital RGB simultaneously, connect
only one of either RGB or HDMI IN (or HDMI/DVI
IN) to display the PC output on the TV.
If the graphic card on the PC does output
G
analogue and digital RGB simultaneously, switch
the TV to either RGB or HDMI; (the other mode is
set to Plug and Play automatically by the TV.)
DOS mode may not work depending on the video
G
card if you use a HDMI to DVI cable.
If you use too long an RGB-PC cable, there may be
G
interference on the screen. We recommend using
under 5m of cable. This provides the best picture
quality.
OPTICAL
I N
AUDIO IN
DIGITAL
AV 1
(RGB/DVI)
AUDIO OUT
RGB IN (PC)
RS-232C IN
(CONTROL & SERVICE)
2
AUDIO
19