Adjustable 6 - 12 metres
Base of product
3m
6m
8m
12m
120˚
Detection range can be adjusted
Duration the bulb stays on is
by turning 'Sens' screw
adjustable by turning 'Time' screw
Fitting/replacing bulbs
When changing a bulb, always switch off at the mains and allow the bulb to cool before handling.
Dispose of used bulbs carefully.
Do not exceed the wattage stated from that indicated on the fitting.
To access the bulb, remove the decorative nuts on top of the shade, and lift off the top. Set aside.
Relocate the shade top over the screws and secure in place with the screws.
Care and cleaning
Do not use solvents or abrasive cleaners as these could damage the finish.
Glass - Remove and wash in warm water or just use a damp cloth. Do not use abrasive materials.
Do not clean the units with a pressure washer.
Recycling advice
Waste electrical products should not be disposed of with household waste. Please recycle where facilities
exist. Check with your Local Authority or retailer for recycling advice.
Safety information
For your safety, always switch off the supply before changing lightbulbs, or cleaning.
This bulb is protected by a shade. This part must be replaced immediately should the shade
Replace Cracked
become cracked or damaged. This fitting must not be used without the shade in place.
Shade
Please note this product is fitted with
a daylight sensor, therefore it will only
activate once the ambient light level
drops below 10 Lux.
TIME
SENS
PIR Coach Lantern
5543J
27/08/2015
Need help?
Do you have a question about the 5543J and is the answer not in the manual?
Questions and answers