Comfort Glow GLD2466R Manual page 21

INSTALLATION
BEFORE INSTALLING THE APPLIANCE
- Turn off gas supply to fireplace or firebox.
- Clean fireplace floor and chimney before installing log set. Seal any ash. Clean out doors to protect
the unit from down drafts.
MOUNTING ASSEMBLY PROCEDURE
- Place grate/burner assembly into firebox with the front pan facing forward.
- Drill two (2) 5/32" diameter holes approximately 1" deep.
- Anchor the front pan to the floor using the (2) Concrete Attachment Screws (Not Included).
(See Fig. 11.1).
- Proper installation of the grate is essential to prevent any movement of the gas logs and
controls during operation.
Mark Hole Location using
Log Set and Drill 2 Holes
approx. 1" deep to accept
Concrete Screws (Both Sides)
20
(2) #12 x 3/4 Hex Flange
Head Concrete Screws
Fig. 11.1