Summary of Contents for Jenile DDG14
- Page 1 Gas Detector INSTRUCTION MANUAL Specially designed for deaf and hearing impaired people. POWER ALARM FAULT...
- Page 2 All your products are already connected to each other.
- Page 3 Summary : The contents of your package Gas Detector 5-10 :...
-
Page 4: The Contents Of Your Package
The contents of your package - Gas detector - Power cable - 2 pegs D - 2 screw - Manual instruction in english... -
Page 5: Gas Detector
Gas Detector D - Test button - LED power - Power cable - LED alarm - LED fault Technical Specifications Easy and simple of installation Sound power: 85 dB Power supply: 220 V AC Transmission frequency: 433,33 Mhz Temperatures: -10° - 50° Humidity : <95% Size: 113*45mm Response time: <30 seconds... -
Page 6: Installation
The consequences of these types of explosion are severe and can cause long-term sequelae or death. The gas detector DDG14 This wall-mounting detector is recommended to monitor the concentration of combustible gases (natural gas, gas-propane, butane gas). When the concentra- tion reaches a risk level, i.e concentration above 10%, the detector activates a visual... - Page 7 Ideal location for a CO detector Space without air circulation. If the detector is installed on the wall, it must be installed At least 15 cm from the ceiling. 15 cm at least Above the level Top of doors And windows At least 30 cm Of any obstacle Between 1 and 3m depending on...
- Page 8 Working principle Preheating : The detector requires a warm-up time. The “power” lamp lights up in green and “W-up” lights up in yellow. 4 to 5 minutes after, the yellow light turns off and the device is fully operational. Sleep mode and alarm: If no gas is detected, only the green light will remain lit up. If an abnormal presence of gas is detected, the “Alarm”...
- Page 9 Warning, if you press too long on the CBM cube plug, it will be disconnected. Press on the test button to activate the alarm, then the LED flashes quickly and it transmits the signal to Jenile wireless flash receivers or vibrators. Care It is recommended to test the detector every week (cf test mode) and clean the openings in the event of dust being present.
- Page 10 Signals and colors The gas detector DDG14 can be used with all the receivers from the Jenile range. If you need to be alerted to the gaz detector, the cube, the flash plug,will turn red. The pocket vibrator has 3 vibrations with 5 repetitions.
- Page 11 www.jenile.com...