Related Manuals for PEMTECH PT800 Series
Summary of Contents for PEMTECH PT800 Series
- Page 1 Gas Detection Technology Model PT800 Series Repeater ISM: 2.4 GHz Revision 2 October 2015 Pem-Tech, Inc. Houston, Texas U.S.A www.pem-tech.com...
-
Page 2: Specifications
1.0 Specifications Power Input 12 VDC Power Consumption < 1 watt (nominal) Enclosure Copper free Aluminum Instrument enclosure CSA / UL / ATEX Approved for Class I Division 1 Cable Entry ¾ “ NPT Female threads for Cable Glands RF Frequency 2.4 GHz ISM Band, frequency hopping wide band modulator IEEE 802.15.4 Compliant RF Certification... -
Page 3: Installation
2.0 Installation See Figure 1 & 2 for installation and wiring diagram. Pole mount bracket for the antenna is provided. Antenna must be installed at a height so it is in good line of sight with all the wireless detectors or gateways in the field as well as with main control panel. - Page 4 If the repeater is installed permanently then proper insulation / weather stripping tape must be installed onto the coax connection both at the antenna and at the Repeater end to protect against harsh environmental conditions. Select the Zone via Blue Rotary switch on the front Panel. ...
-
Page 5: Operation
3.0 Operation On the front panel there are 3 status LEDs • Green: Power On • Amber: Different flashing rate represent the operating modes • Red: Fault Condition When power is applied to the unit. Amber and Red LEDs starts flashing alternately for 5-10 seconds indicating the initializing mode ... - Page 6 1Foot Length Surge Arrestor Select Zone / Network ID Must Connect earth ground PT800 Series Wireless Repeater Coax Cable PT800-XP-09 (900 MHz) with External Omni Antenna and surge Arrestor PT800-XP-24 (2.4 GHz) ...
- Page 7 Dipole Antenna PEM-TECH Model 800-XP Repeater Select Zone/ Network ID +12 VDC POWER IN PT800-XP-09 (900 MHz) Model PT800 Series Wireless Repeater PT800-XP-24 (2.4 GHz) ...