Download Print this page

Lark Manor ZH1087-2 Assembly Instructions

Grey micro/ zh1087-3 khaki micro tufted storage lounge

Advertisement

Quick Links

Product Instructions for:
ZH1087-2 GREY MICRO/ ZH1087-3 KHAKI MICRO
TUFTED STORAGE LOUNGE
Assembly Instructions
NOTE: Before you get started, remember to loosely attach all bolts. Once
product is fully assembled, set product upright. Press down evenly on all sides
until product sits level then fully tighten all bolts.
For assistance with assembly or questions contact:
Wayfair Customer Service, 877-WAYFAIR (877-929-3247) |
www.wayfair.com
PAGE 1

Advertisement

loading

Summary of Contents for Lark Manor ZH1087-2

  • Page 1 Product Instructions for: ZH1087-2 GREY MICRO/ ZH1087-3 KHAKI MICRO TUFTED STORAGE LOUNGE Assembly Instructions NOTE: Before you get started, remember to loosely attach all bolts. Once product is fully assembled, set product upright. Press down evenly on all sides until product sits level then fully tighten all bolts.
  • Page 2 ZH1087-2 GREY MICRO/ ZH1087-3 KHAKI MICRO TUFTED STORAGE LOUNGE Before beginning assembly, separate all parts and carefully study the parts diagrams below. Review all parts and hardware before disposing of any packaging. You may receive extra hardware with your unit. Call Customer Service for missing hardware.
  • Page 3 ZH1087-2 GREY MICRO/ ZH1087-3 KHAKI MICRO TUFTED STORAGE LOUNGE Assembly Instructions Step 1 Unpack and lay parts on clean, Padded surface like carpet or blanket. Check that you have all parts indicated on the front page. Open the Seat (A) cover and keep the Seat (A) cover open.
  • Page 4 Step 3 Attach Side Panel (C) to Seat (A) and Back Panel (B) by Blots (1) and Spring Washer (2) and Big Flat Washer (3), Tighten them by using Allen Wrench (5) as shown in Figure 3. Figure 3 Step 4 Lift the Velcro strip from the side of Side Panel (C).
  • Page 5 Step5 Attach Legs (D) into the holes of Seat (A) and Back Panel (B), insert Blots (1) and Spring Washer (2) and Small Flat Washer (4) into holes of Legs (D), Tighten them by using Allen Wrench(5), Then insert the Plastic Plug(6) to the Legs (D) as shown in figure 5.

This manual is also suitable for:

Zh1087-3