Help With The Appliance - Bosch WTR86T9ESN Installation And Operating Instructions Manual

Help with the appliance

en
3
Help with the appliance
H e l p w i t h t h e a p p l i a n c e
Faults
Appliance does not start
Creasing.
Water is leaking out.
The appliance is paused but the
drum is turning.
The programme does not start Make sure that:
Programme duration displayed
changes as drying progresses.
Laundry is not dried properly or
is still too damp.
42
Cause/Remedy
Check the mains plug and the fuses.
Load exceeded or incorrect programme selected for a type of fabric.
■
All the required information can be found in the programme
table.~ Page 22
Remove laundry from the drum as soon as the drying programme
■
has finished. Creasing occurs when clothing is left in the drum.
The appliance may be positioned at an angle. Level the appliance.
■
In the base unit, make sure that:
■
– The heat exchanger cover is properly locked.
– There is no dirt or debris on the heat exchanger cover's seal.
~ Page 39
If the optional drain hose* is installed, make sure that the drain hose
■
is correctly connected. ~ Page 35
The appliance has detected a high temperature and has started the
CoolDown process. Temperature regulation can take up to 10 minutes.
You can cancel the CoolDown process at any time by opening the door.
The door is closed
■
The E 3 sec. (Child Lock 3 sec.) has been deactivated
■
You have pressed A (Start/Reload)
■
Note: If the programme has been delayed by setting ñ (Finished in) , the
programme starts at a later point.
Not a fault. The moisture sensor measures the residual moisture in the
laundry and adjusts the programme duration (with the exception of timed
programmes).
After the programme has ended, warm laundry feels damper than it
■
actually is. Spread out the laundry and let it cool down.
Adjust the drying time or increase the degree of dryness. This will
■
extend the drying time but the temperature will remain the same.
Select a timed programme to add extra drying time for laundry that is
■
still damp.
Select timed program for a small load and individual items of laun-
■
dry.
Do not exceed the maximum load for a programme.~ Page 22
■
Clean the moisture sensor in the drum. The sensor may become cov-
■
ered in a fine layer of limescale or detergent and care product resi-
due, which then impairs its performance.~ Page 38
Drying has been interrupted as a result of a power cut, because the
■
condensation container is full or because the maximum drying time
has been exceeded.
See also the laundry tips.~ Page 25
Note: