WilTec 62739 Operation Manual page 6

Installation
Installing the flange
Put the flange onto the generator spindle. Mount the generator to the device and make sure that it is
straight. Put the high-quality steel plate on top, apply light pressure, and tighten the screw-nuts.
Connecting to the command
Gently turn the rotor blades a bit after mounting of every piece. Check if all pieces are correctly mounted
and tightened, and then put the device on its support. Connect cables, recharger, and batteries.
ATTENTION
•
An external control is not required.
•
The wind generator does not need to be connected to a regulator, but can be connected directly
to the battery. The red wire of the wind generator is connected to the positive electrode of the
battery, the blue wire is connected to the negative electrode.
•
Welding the flange to the device is not necessary.
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
Item 62739–62740 Page 6
10 2021-1