Speaker; Knob (Pot); Knob (Dial); Earphone Jack With Nut - Elenco Electronics AM/FM-108TK Assembly And Instruction Manual

ASSEMBLY INSTRUCTIONS
Note: Mount the Pot/SW, earphone jack,
and speaker to the foil side of the PC
board.
Solder all 5 tabs to PC board
Figure F
Figure G
If the speaker pad has center and outside pieces, then
remove them. Peel the backing off of the speaker pad and
stick the pad onto the speaker. Then stick the speaker
onto the solder side of the PC board as shown.
Remove
Your kit may contain a different type of earphone jack. Before installing
the jack, determine which one you have.
Foil Side
GND Pad

Nut

2
3
1
1 - GND
2 - Tip
Part # 622130
3 - N.C. Tip
Mount the jack with the nut from the foil side of the PC board (terminal #1
on the GND pad of the PC board). Be sure to line up the tab with the pad
on the copper side of the PC board. Solder terminal #1 to the pad of the
PC board.
Knob
Nut
Washer
Cut off
locating pin

Plastic Washer

Figure H
Foil Side
2
Nut
3 1
1 - GND
2 - Tip
Part # 622131
3 - N.C. Tip
Pad
Backing

Speaker

1.5" Wire
GND Pad
1" Wire
Part # 622130
Cut three wires 1", 1.5" and 1.5" and strip 1/4" of insulation
off of both ends. Solder the 3 wires as shown. Save the
extra wire for the FM Section.
-8-
Battery Holder
3 Screws 2-56 x 1/4"
3 Nuts 2-56
Solder and cut off
excess leads.
Volume/S2
(50kΩ Pot / SW)
with Nut & Washer
Plastic Washer

Knob (pot)

(see Figure F)
Earphone Jack
with Nut
(see Figure H)
Speaker
Speaker Pad
Wire #22 Insulated
(see Figures G & I)
Backing
Figure I
1.5" Wire
1.5" Wire
1" Wire
Part # 622131
From
Terminal 3
1.5" Wire