Step 1: Pipe Assembly; Step 2: Stand Assembly; Step 3: Head Assembly - Lasko S18355 Operating Manual

MODELO S18355
FUNCIONAMIENTO
Este Ventilador puede hacerse funcionar mediante los
Controles Manuales ubicados en la parte superior de
la unidad (como se muestra en la Figura 10) o con el
Control Remoto (se muestra en la Figura 13.
1. Conecte el cable eléctrico a un tomacorriente de 120 V~.
2. Conecte la energía eléctrica a su ventilador pulsando el
Botón Alimentación ( ).
3. VELOCIDAD DEL VENTILADOR: Ahora puede ajustar
la velocidad del ventilador presionando el botón de
velocidad del ventilador ( ).
4. OSCILACION: Empuje la perilla ubicada en la parte su-
perior de la caja del motor para hacer que la cabeza del
Ventilador se mueva de un lugar hacia otro. (Figuras
11 y 12)
5. Después de apagar el Ventilador, desconecte la unidad
del tomacorriente eléctrico.
New 11/13
Botón
Velocidad del Botón
Ventilador Alimentación
Figura 10
Hacia Arriba: Estacionario
Hacia Adelante: Oscilar
Figura 11
Figura 12
10

STEP 1: PIPE ASSEMBLY

1. Take pipe assembly out of carton as shown.
2. Loosen Height Adjustment Nut turning counter clockwise.
3. Raise Extension Pipe.
(Figure 3)
4. Tighten Height Adjustment Nut turning clockwise.
Extension
Pipe
Height
Adjustment
Nut
Figure 1 Figure 2

STEP 2: STAND ASSEMBLY

PLACE BASE FLAT ON FLOOR
1. With a twisting motion, insert the end of the large diameter
pipe into hole in Base. (Figure 5) Turning pipe while pushing
will assure pipe is fully seated in Base.
2. For Height Adjustment:
a) Loosen Height Adjustment Nut.
b) Raise or lower Extension Pipe to desired height.
c) Tighten Height Adjustment Nut.
Extension Pipe
Height
Adjustment Nut
Base
Figure 5

STEP 3: HEAD ASSEMBLY

Assembly
1. Place Head Assembly with
Collar onto Extension Pipe.
(Figure 6)
2. Holding Extension Pipe
firmly, twist Head Assembly
downward until seated on
Extension Pipe.
Figure 6
2084836 New 11/13
Do Not take pipe apart. Should pipes become separated, insert
pipe A into pipe B.
(Figure 1)
(Figure 2)
(Figure 4)
STEP 4: BLADE & GRILL ASSEMBLY
1. Tilt Head Assembly back. Put Rear Grill on Head Assembly.
(Figure 7)
2. Align tab of Plastic Rear Grill with groove on top of front
Head Assembly.
Figure 3 Figure 4
Rear
Grill
Figure 7
3. Fully seat Rear Grill and secure with Plastic Nut turning Clock-
wise. Slide Blade onto Motor Shaft. (Figure 8) Align Groove on
blade hub with Pin on motor shaft. (Figure 8A)
Rear Grill
Larger
Pipe
Figure 8
Head
Figure 8A
Collar
4. To secure Blade, screw Fan Spinner onto Shaft
Counter Clockwise until tight on Blade hub.
5. With fan head in upright position, align Ornament of Front Grill
so it is horizontal and right side up. By starting with the top of
Extension
the grill and working down, insert Snaps on Rear Grill through
Pipe
Slots in Front Grill.
3
B
A
Head
Assembly
Blade
Fan
Plastic
Spinner
Nut
Pin
Groove
2084836