Table of Contents
Advertisement
FINAL ASSEMBLY (continued)
Place the front panel onto the case and secure it with four 4 x
1/2" screws (see Figure 13).
4 x 1/2" Screws
CAUTION: High voltage present on the PC board. DO NOT handle it while in operation!
OPERATION
1. Turn the unit on by adjusting the knob clockwise. The unit should flash once per second (1Hz) at the lowest
setting. Increase the flash rate up to four times per second (4Hz) by turning the knob clockwise. Note that
the flash may be erratic when set to the maximum position.
The maximum flash rate can be adjusted to approximately 4 times per second.
Knob - Turn the shaft on the pot counter-
clockwise all of the way. Install the knob with
the line pointing in the direction as shown in
Figure 14.
Figure 13
-9-
Figure 14
Advertisement
Table of Contents
