Subscribe to Our Youtube Channel
Related Manuals for Geba Tronic Cody Universal 1/1
Summary of Contents for Geba Tronic Cody Universal 1/1
- Page 1 Cody Universal Assembly, connection and maintenance of the device may only be executed by personnel trained accordingly. At this the underlying national and local regulations have 1/1 1/2 1/3 to be observed.
-
Page 2: Master Code
Device description Note: Optional Cody Universal Service Tool The Cody Universal consists of a decoder and a control element. Both units are connected by a simple two-wire cable without a The Cody Universal Service Tool gives you the possibility to program special plug. -
Page 3: General Reset
General reset General reset Put DIP switch Push reset button Put DIP switch 4 to back to OFF ATTENTION!!! on the PCB > 5 sec. After you have made yourself familiar with the functions of the appliance, please program your personal mastercode as well as a pass code with which you replace the pass code which is located on the memory place 00. -
Page 4: Mounting Instructions
RC transmitter Mounting instructions Program 2 Deleting of remote controls Interior mounting of the logic: Delete specific transmitter: 1. Put the screw-driver into the gap of the enclosure front, push the screw-driver up and Set DIP of the Press the button of the open the enclosure. -
Page 5: Technical Data
RC transmitter Program 1 Technical data Teach-in of remote controls Supply voltage: 20-28V AC/DC, 230-240 V AC Output: 250V AC 5A Connections: 1.5 mm² max. Make sure before the teach-in that the optional wireless module is plugged in firmly at the logic board. Ambient temperature: -20 °C to +60 °C Press the desired Put DIP of the... -
Page 6: Programming Instructions
Keypad Transponder Program 2 Programming Deleting transponder keys instructions Delete specific keys: LED flashes Please read first - then do programming!!! Put the desired Put DIP of the 2x long key to the taught-in key Set all DIP to reader to ON Before programming your Cody Universal with your personal codes, please check the faultless function of the appliance with the help of the factory‘s pass code 1234 and the... - Page 7 The transponder key is programmed to the desired relay or block! *Note: Only for Cody Universal 1/2 or 1/3 Cody Universal 1/1 The keys are distributed among three blocks of 255 keys per color. The blocks correspond to the first push 3 DIP switches.
- Page 8 Keypad Keypad Program 8 Program 3 Entering a pass code Deleting a pass code Enter 4 or 5 digit push Enter of 2 digit push pass code sound signal push memory slot, Enter 8 digit sound signal 2x long e.g. 07 or 28 master code 1x long button...
- Page 9 Keypad Keypad Program 4 Program 7 Changing the control time - switching time Entering the control mode Entering the control mode*: push sound signal push push push Enter 8 digit 2x long push Enter 8 digit sound signal push Button mastercode mastercode 2x long...
- Page 10 Keypad Keypad Program 6 Program 5 Changing the control time - lock-out time Changing the control time - Tiptomatic-time push push push sound signal Enter 8 digit 2x long push push mastercode push sound signal Enter 8 digit 2x long button button button...
Need help?
Do you have a question about the Cody Universal 1/1 and is the answer not in the manual?
Questions and answers