Related Manuals for King Canada PERFORMANCE PLUS 8199N
Summary of Contents for King Canada PERFORMANCE PLUS 8199N
- Page 1 ELECTRIC HVLP SPRAY GUN MODEL: 8199N INSTRUCTION MANUAL COPYRIGHT © 2020 ALL RIGHTS RESERVED BY KING CANADA TOOLS INC.
-
Page 2: Proof Of Purchase
Contact your retailer or visit our web site at www.kingcanada.com for an updated listing of our authorized service centers. In cooperation with our authorized service center, King Canada will either repair or replace the product if any part or parts covered under this warranty which examination proves to be defective in workmanship or material during the warranty period. - Page 3 GENERAL SAFETY WARNINGS FOR POWER TOOLS WARNING! Read all safety warnings and all instructions. Failure to follow the warnings and instructions may result in electric shock, fire and/or serious injury. Save all warnings and instructions for future reference. The term "power tool" in the warnings refers to your mains-operated (corded) power tool.
- Page 4 GENERAL SAFETY WARNINGS FOR POWER TOOLS 3) Personal safety continued... e) Dress properly. Do not wear loose clothing or jewellery. Keep your hair, clothing and gloves away from moving parts. Loose clothes, jewellery or long hair can be caught in moving parts.
- Page 5 SPECIFIC SAFETY WARNINGS FOR SPRAY GUNS SPECIFIC SAFETY INSTRUCTIONS FOR SPRAY GUNS 1) Keep area clean well lit and free of paint or solvent containers, rags, and other flammable materials. Spontaneous combustion may occur. Fire extinguisher equipment must be present and working at all times. 2) Provide for good ventilation in the spraying area and for sufficient fresh air in the complete room.
- Page 6 ELECTRICAL INFORMATION & SPECIFICATIONS Warning: The warnings, cautions, and instructions discussed in this instruction manual cannot cover all possible conditions and situations that may occur. It must be understood by the operator that common sense and caution are factors which cannot be built into this product, but must be supplied by the operator.
-
Page 7: Getting To Know Your Tool
GETTING TO KNOW YOUR TOOL, PREPARATION & THINNING GETTING TO KNOW YOUR TOOL 1. Width setting nozzle (2.6mm installed) 2. Spray pattern adjusting nozzle cap 3. Spray width adjusting lever 4. Nozzle cap locking nut 5. Spraying attachment 6. Attachment lock knob 7. - Page 8 OPERATION & ADJUSTMENTS FILLING THE PAINT CONTAINER WARNING! Make sure the spray gun is unplugged. 1) Unscrew the container (A) Fig.2 from the spray gun attachment. 2) After the paint/material has been properly thinned, fill the container. Never fill over the max fill level of 1 liter (1000 ml).
-
Page 9: Flow Rate Adjustment
OPERATION & ADJUSTMENTS SETTING SPRAY PATTERN continued... 1) Make sure the spray gun is turned off. 2) Loosen the nozzle cap locking nut (A) Fig.4. 3) Adjust position of the nozzle cap (B) to obtain the vertical, horizontal or round pattern. 4) Once the desired spray pattern is obtained, retighten the nozzle cap locking nut. -
Page 10: Maintenance
2) Remove diaphragm (C) Fig.7 from ventilation hose Figure 7 (D), clean all parts and reinstall in reverse order. PARTS DIAGRAM & PARTS LISTS Refer to the Parts section of the King Canada web site for the most updated parts diagram and parts list.