Table of Contents
Advertisement
PLM Channel:
Vin Startup:
String Count:
Enable PVRSS:
Cancel
Figure 6-4. PVRSS Commissioning (2 of 3)
6. See
Figure
6-5. The LCD will display Test-
ing PRVSS during the testing process.
Upon completion, the LCD will read Low
Sun or Making Power, depending upon
available PV voltage.
PWRcell X7602
Photovoltaics
testing PVRSS
Power:
PV Voltage:
E-total:
Figure 6-5. PVRSS Commissioning (3 of 3)
Setpoint
PLM Channel
Vin Strartup
String Count
Enable PVRSS
SnapRSIn-
stalled
SnapRSDe-
tected
Override
PVRSS
18
135.0V
Commit
-xx
115v
59.0kWh
010033
Range
Default
1-12
60-135 Volts
135V
1-2
on/off
0-10
0-10
on/off
7. Complete steps 1 – 6 for each PV link in
the system.
1
SnapRSInstalld:
2
SnapRSDetected:
on
Override PVRSS:
012924
NOTE: To verify a PV Link is working properly,
navigate to the Mod.Settings page and con-
firm the SnapRSInstalld value matches the
number of SnapRSDetected.
0W
Channel for REbus communications. All devices in a sys-
1
tem must use the same channel (except REbus Beacon).
Minimum input voltage from the PV substring for the PV
Link to make power.
Number of substrings plugged into the input of a PV Link.
1
Set to a value of 2 if paralleling two series substrings for
high voltage, 96 cell solar panels.
Enables the photovoltaic rapid shutdown system
off
(PVRSS). Turn this setting 'on' by selecting to 'Enable w/
PVRSS' if SnapRS are installed.
This is the number of SnapRS that are counted and
0
stored upon the first successful count of SnapRS.
This is the number of SnapRS that are detected after
0
each subsequent count. Counts occur daily.
This setting overrides a key feature of the PVRSS, clos-
ing the SnapRS devices without requiring a count. Do not
off
leave override 'on.' Use only for temporary troubleshoot-
ing purposes.
Installation Manual for PV Link and SnapRS
Cancel
Figure 6-6. SnapRS Check
Description
7
7
off
Commit
012943
Advertisement
Table of Contents
