Ironton 41484 Owner's Manual

LINEAR ACTUATOR
OWNER'S MANUAL
WARNING:
Read carefully and understand all ASSEMBLY AND OPERATION
INSTRUCTIONS before operating. Failure to follow the safety rules and
other basic safety precautions may result in serious personal injury.
IItem#s 41484, 41485 & 41486
Thank you very much for choosing an Ironton product. For future reference, please complete
the owner's record below:
Model: _______________ Purchase Date: _______________
Save the receipt, warranty and these instructions. It is important that you read the entire manual
to become familiar with this product before you begin using it.
This item is designed for certain applications only. The distributor cannot be responsible for
issues arising from modification. We strongly recommend this item not be modified and/or used
for any application other than that for which it was designed. If you have any questions relative
to a particular application, DO NOT use this product until you have first contacted the
distributor to determine if it can or should be performed on the product.
For technical questions please call 1-800-222-5381.

TECHNICAL SPECIFICATIONS

Item# 41484
Stroke Length 3 15/16in. (100mm)
Rated Load Thrust
Maximum Load
No-load Speed
Load Speed
Rated Voltage
Mounting Hole Dia.
Gear Ratio
Duty Cycle
Ambient Temperature
Protection Class

GENERAL SAFETY RULES

WARNING: Read and understand all instructions.
listed below may result in serious injury.
CAUTION: Do not allow persons to operate or assemble this linear actuator
until they have read this manual and have developed a thorough understanding of
how the linear actuator works.
WARNING: The warnings, cautions, and instructions discussed in this
instruction manual cannot cover all possible conditions or situations that could
occur.
It must be understood by the operator that common sense and caution are factors
which cannot be built into this product, but must be supplied by the operator.

SPECIFIC WARNINGS AND PRECAUTIONS

1. Read and understand the manual before using this linear actuator.
2. Test battery before operation to make sure the battery has adequate power to lift the linear
actuator.
3. Stop working and switch off the power before changing the direction. If you change the
direction when the motor is running, the motor may be damaged.
4. If the linear actuator is connected to the power source incorrectly, it may run exceeding its
stroke, and may run in wrong direction.
5. Do not open actuator manually. This can cause damage to the actuator.
LINEAR ACTUATOR OWNER'S MANUAL
41485 41486
7 7/8in. (200mm) 11 13/16in. (300mm)
675 LBF (3000N)
1350 LBF (6000N)
8mm/s
5.5mm/s
12V DC
0.4in. (10.2mm)
1:18.5
10%
23°F – 104°F
IP44
Failure to follow all instructions
1 of 5