Summary of Contents for PCS Electronics PEBBLE
- Page 1 Please read these instructions fully before you begin installation to ensure you have everything ready.
- Page 2 ◦ Your home internet wireless connection BlinkUp ◦ We use this to describe the process of connecting your Pebble device to your home Wi-Fi network. Sharing ◦ The term used to describe sharing the setup you have made to anyone else with a smartphone in your household.
- Page 3 Please ensure your smartphone is connected to your home Wi-Fi, and have your home Wi-Fi password handy ◦ Write in the box below for reference latter ◦ DO NOT plug the pebble into the power yet… this is done at step 7...
- Page 4 Important – Ensure your phone display brightness is on high (this is required for the setup to work later) Download the Pebble Air Application to your smartphone ◦ Visit Then open the Application ...
- Page 5 Open the Pebble Air app Go to Settings ...
- Page 6 Sample only Select BlinkUp Pebble Choose your Home Wi-Fi from the list & select it ...
- Page 7 Sample only Use show password, this ensures the correct password is entered Enter your home Wi-Fi password ...
- Page 8 Using the supplied low voltage transformer, plug your Pebble into a local electrical socket. (Your Pebbles LEDs will start flashing) It is important this is not done until now as part of the setup procedure.
- Page 9 Plug in the Pebble, press the “Send BlinkUp” button and immediately place the pebble on top of the screen of your smartphone, as shown above...
- Page 10 then the process has failed and it will need to be repeated. Re- do from STEP 7 Ensuring you un-plug the Pebble and wait approx. 30 seconds before plugging back in again. Other flashing codes are shown in the complete manual provided ...
- Page 11 Press Select Remote Choose the Brand of your Air Conditioner / Heat Pump Choose the Remote Control Model Number for your selected air- con/heat-pump brand (which will be found on your remote control) Press the Save button ...
- Page 12 For other features like “Sharing the App” please refer to the full manual available from www.pebbleair.com/downloads You must position your Pebble carefully in a considered location. It is vital that the Pebble can see the front of the air-con/heat- pump(where the infra-red receiver is) as infra-red signals cannot see around corners or go through walls.
Need help?
Do you have a question about the PEBBLE and is the answer not in the manual?
Questions and answers