Related Manuals for KegLand Fill-O-Meter
Summary of Contents for KegLand Fill-O-Meter
- Page 1 Fill-O-Meter Instruction Manual Fill-O-Meter Instruction Manual KL14694 KegLand Distribution PTY LTD www.KegLand.com.au www.KegLand.com.au Last Updated 5/10/2020 3:59 PM Page 1 of 6...
-
Page 2: Default Display
Fill-O-Meter Instruction Manual WARNING DO NOT OVERTIGHTEN FITTINGS ONTO THE INPUT OR OUTPUT THREADS. DO NOT EXCEED 5NM OF TORQUE. WARNING DO NOT EXCEED A WATER TEMPERATURE OF 40°C WARNING DO NOT USE WITH LIQUIDS OTHER THAN WATER WARNING ONLY ATTACH MAINS WATER TO THE INLET WITH FILTER IN PLACE... - Page 3 1.1 Operation as a Common Water Meter When there is no set value (i.e. the set value is 0000.00L) the Fill-o-meter will operate as a common water meter. Hence, when START/STOP is pressed the solenoid valve will open and remain open until START/STOP is pressed again, resulting in the solenoid valve closing.
- Page 4 Fill-O-Meter Instruction Manual 2. Quantitative Statistics By default the Fill-O-Meter will display the total volume delivered as the instantaneous value. However, other quantitative statistics such as Daily Total Volume and Instantaneous Flow Rate can be displayed. To switch between quantitative statistics press the MENU button while in standby mode. The three quantitative statistics which can be displayed are as follows: 1.
- Page 5 Fill-O-Meter Instruction Manual 3. Calibration 1. Press MENU 3 times and the factory setting (009.40 LPM) will be displayed as the instantaneous value 2. Press SET for 3 seconds and use the up and down arrows to set the pin number to 1234 (default password) 3.
-
Page 6: Changing The Calibration Password
KegLand then send an email to Warranty (Australia) The Fill-O-Meter comes with a 3 Year Warranty when sold in Australia. To lodge a warranty claim in Australia please forward as many visual pieces of supporting information and a detailed description...