PDS WorkSafe AZ 700 Series Instruction Manual

there are many hazards that may affect the performance of the equipment and corresponding
safety precautions that have to be observed during equipment utilization, especially: - trailing or
looping of lanyards or lifelines over sharp edges, - any defects like cutting, abrasion, corrosion, -
climatic exposure, - pendulum falls, - extremes of temperature, - chemical reagents, - electrical
conductivity.
personal protective equipment must be transported in the package (e.g.: bag made of moisture-
proof textile or foil bag or cases made of steel or plastic) to protect it against damage or moisture.
the equipment can be cleaned without causing adverse effect on the materials in the
manufacture of the equipment. For textile products use mild detergents for delicate fabrics, wash
by hand or in a machine and rinse in water. Plastic parts can be cleaned only with water. When the
equipment becomes wet, either from being in use or when due cleaning, it shall be allowed to dry
naturally, and shall be kept away from direct heat. In metallic products some mechanic parts
(spring, pin, hinge, etc.) can be regularly slightly lubricated to ensure better operation.
Other maintenance and cleaning procedures should be adhered to detailed instructions stated
in the manual of the equipment.
personal protective equipment should be stored loosely packed, in a well-ventilated place,
protected from direct light, ultraviolet degradation, damp environment, sharp edges, extreme
temperatures and corrosive or aggressive substances.
IT IS THE RESPONSIBILITY OF THE USER ORGANISATION TO PROVIDE THE IDENTITY CARD AND TO FILL IN
THE DETAILS REQUIRED. THE IDENTITY CARD SHOULD BE FILLED IN ONLY BY A COMPETENT PERSON
RESPONSIBLE FOR PROTECTIVE EQUIPMENT .
FIRST USE OF THE EQUIPMENT . ANY INFORMATION ABOUT THE EQUIPMENT LIKE: PERIODIC
INSPECTIONS, REPAIRS, REASONS OF EQUIPMENT'S WITHDRAWN FROM USE SHALL BE NOTED. THE
IDENTITY CARD SHOULD BE STORAGED DURING A WHOLE PERIOD OF EQUIPMENT UTILIZATION. DO NOT
USE THE EQUIPMENT WITHOUT THE IDENTITY CARD.
IDENTITY CARD
MODEL AND TYPE OF EQUIPMENT
REF . NUMBER
SERIAL NUMBER
USER NAME
DATE OF PURCHASE
PERIODIC EXAMINATION AND REPAIR HISTORY
REASON FOR CONDITION OF DEVICE
DATE
SERVICING/REPAIR
1
2
3
4
5
PDS International Pte Ltd ; 10 Pandan Crescent, #05-03/04 (LL2) ; UE Tech Park ; Singapore 128466
Tel : +65 6776 6200 ; Fax : +65 6778 2400
THE IDENTITY CARD SHOULD BE FILLED IN BEFORE THE
DATE OF MANUF .
DATE OF FIRST USE
NAME AND SIGNATURE
OF COMPETENT PERSON
AFTER SERVICING
Instruction Manual
EN 795:1996 Class B
ESSENTIAL FEATURES
The Webbing Sling AZ 700 is a component of personal protective equipment against falls from a
height. It is designed to use as an anchorage device class B for temporary attaching falll arrest
system to a rigid structure.
The Webbing Sling is made of polyamide/polyester webbing, lined with rubber strap and equipped
with steel D-rings on both ends. The length of the sling can amount up to 2 meters.
TIME OF USE
The webbing sling can be used for 5 years,
counting from the date of putting the device into
operation. After 5 years of use the connector must
be withdrawn from use and destroyed.
WITHDRAWN FROM USE
The webbing sling must be withdrawn from use
and destroyed when:
- it was used more than 5 years from the date of
putting it into operation.
- it was used to arrest a fall.
- any mechanical, chemical or thermal defects
have appeared.
EQUIPMENT COMPATIBILITY
Using the webbing sling in connection with fall
arrest system must be compatible with use
instructions of the fall arrest systems and
obligatory standards:
- EN 361 - for safety harness,
- EN 353-1, EN 353-2, EN 354, EN 355, EN 360,
EN 362 - for fall arrest systems,
- EN 795 - for anchorages,
- EN 358 - for work positioning systems.
NEXT
EXAMINATION
DATE
MARKING
name of the product
reference number
type of the device
European standards
CE mark and number of notified body
inspecting the equipment according to
the article 11 of Directive 89/686/EEC
EC type examination carried out by CETE APAVE SUDEUROPE, BP 193, 13322 Marseille, France - 0082
WEBBING SLING
Reference number: AZ 700 xx
(xx - marking of working length)
load
bearing
tape
identity
label
D - ring
month and year
of manufacture
caution: read
the manual
Length: 90 cm
manufacturer
®
f
or distributor
®
f
rubber
liner