Page 1
Installation and User Guide Nouveau FT/RT...
Page 2
Thank you for purchasing an Americh International bath. This bath is made from two skins of acrylic. Before you start Please note that this product has been through our rigid quality control procedures which include a thorough visual and physical inspection. Please unwrap the bath and check it carefully to ensure it has not been damaged in handling or transport which is beyond our control.
Page 3
Certain baths have been designed so the outer skin goes all the way to the floor, as shown in the picture below. Some Americh International baths are made form double skin acrylic there is no panel around technology. Both skins are bonded together as one;...
Page 4
Installation Instructions This bath has been designed for floor or wall mounted taps. The floor which the bath sits on must be as level as possible due to the bath sitting on it’s flat base. As the skirted baths have no panel to remove for access to the waste, an access hole in the base of the outer skin has been cut so connection can be made from the waste.
Page 5
Plumbing The Bath In Again we recommend that the bath be fully installed by a professional/qualified tradesman. Because the waste is already fitted to your bath the next step is to connect it to you outlet pipe and secure it to the floor. A 1 ½”adaptor should be with the bath, this is shown below.
Page 6
Check for leaks before securing to the floor Once you’re satisfied with the waste connection, with the plug in, run a little water into the bath and check for leaks. Take the plug out and let the water drain. Check again for leaks. Then fill the bath half way full, empty and check for leaks again.
Page 7
The surface of the acrylic is very smooth and easy to clean. Americh suggests the use of a non abrasive cleaner. The cleaning of your bath should be on a regular basis.
Need help?
Do you have a question about the Nouveau FT and is the answer not in the manual?
Questions and answers