Advertisement
A
uto
1. Getting into your lift chair. While standing next to your chair, press button
(S7) and raise the chair to a height you can sit against. This height will vary
from person to person depending on the individual's needs. Raise the chair
high enough so you do not have to flop down into the chair. Flopping down
into the chair will damage it and could cause personal injury. Press
button (S5). As the chair continues downward, adjust yourself into a position
that is comfortable to you. Continue holding button until chair is in the seated
position (chair firmly on the floor), then release the button. You can also press
buttons (S6, S8, S9, S10) and the chair will move to those positions.
2. Getting out of your chair. Press button (S7) and raise the chair to a height
that enables you to easily stand. Release the button. Return the chair to the
seated position (S5) (chair firmly on the floor) after getting out of the chair, so
children, pets or obstructions do not get under the chair. Repeat no. 1 when
you want to sit down.
Micro Adjustments
1. To recline the back of the chair, press
button (S1) and hold until the back reaches
the desired position. Then release the button.
2. To bring the back of the chair to an upright
position, press button (S2) and hold until
the back reaches the desired position. Then
release the button.
3. To raise the foot rest and seat, press button
(S3) and hold until the foot rest reaches the
desired position. Then release the button.
4. To lower the foot rest and seat, press
button (S4) and hold until the footrest closes.
Then release the button.
Note: The motors are set to shut off when
they reach their fully extended or fully
retracted position if the selected button
is not released. If you should go past your
desired position, select the button to bring you back to your desired
position. You can repeat the process as often as you like.
Programming the Memory Buttons S5, S6, S8 and S10
Press one of the preprogrammed buttons (S5, S6, S8, S10) and hold until the
chair stops. Press buttons (S1 thru S4) to micro adjust those positions to suit
your needs. Use the following procedure to reprogram (S5, S6, S8, S10) buttons
after you have the chair in your desired position.
D
H
rive
AnD
C
ontrol
8
o
perAtion
Advertisement
