Turbo Button; Connecting Usb Devices - Makita DFJ216 Instruction Manual

Cordless fan jacket
Table of Contents

Advertisement

Turbo button

By pressing turbo button on the battery holder, the
jacket works in turbo mode for quick cooling. Turbo
mode lasts for a minute and then air speed returns to
normal.
1
► 1 . Turbo button
Air flow
Air flow inside the jacket is shown below.
Battery pocket
A pocket is provided for storing the battery holder (with
battery) inside the jacket. Connect the power cable to
the battery holder, and then put it into the pocket and
fasten the snap buttons.
Mesh pocket
For DFJ216 only
Mesh pockets are provided on the back of the jacket for
storing ice packs.
1
► 1 . Mesh pocket

Connecting USB devices

CAUTION:
Connect only devices that are
compatible with the USB power supply port. Not
doing so may cause a malfunction of the battery
holder.
NOTICE:
Before connecting a USB device to
the battery holder (with the battery), always back
up the data on the USB device. Not doing so may
cause a loss of your data.
The battery holder (with the battery) can work as an
external power supply for USB devices.
Open the cover and connect a USB cable (not included)
to the power supply port of the battery holder. Then con-
nect the other end of the cable to the device and turn on
the switch next to the USB port.
The battery holder (with the battery) supplies DC5V, 2.1A.
► 1 . Cover 2. Switch
NOTE: The battery holder may not supply power to
some USB devices.
NOTE: When not using or after charging, remove the
USB cable and close the cover.
NOTE: Battery power is consumed while the switch is
turned on. Always turn off the switch when not in use.
10 ENGLISH
2
1

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dfj416

Table of Contents