JIMS 1672 Instruction Sheet

No.1672-IS
I I n n s s t t r r u u c c t t i i o o n n S S h h e e e e t t F F o o r r T T o o o o l l # # 1 1 6 6 7 7 2 2
C C r r a a n n k k c c a a s s e e B B e e a a r r i i n n g g R R e e m m o o v v e e r r a a n n d d I I n n s s t t a a l l l l e e r r 2 2 0 0 0 0 3 3 - - P P r r e e s s e e n n t t
Use on Twin Cam 2003-Present "Alpha" engines, pinion and sprocket side, main case bearing.
Use on Twin Cam 2003-Present "Beta" (Softail) engines, sprocket side, main case bearing.
NOTE: PLE SE RE D LL INSTRUCTIONS COMPLETELY BEFORE PERFORMING NY WORK!
IF YOU DO NOT KNOW WH T YOU RE DOING, DO NOT DO IT!
No information in this instruction sheet pertaining to motorcycle repair is represented as foolproof or even altogether safe.
Even something safe, done incorrectly or incompletely can and will backfire. You and only you are responsible for the safe-
ty of your repair work and for understanding the application and use of repair equipment, components, methods and
concepts.
Each and every step this tool is designed to do must be carefully and systematically performed safely by you. All informa-
tion listed in this instruction sheet has been tested, re-tested and used daily in JIMS
Department.
LW YS WE R S FETY GL SSES OR OTHER F CE ND EYE PROTECTION SUCH S FULL
F CE SHIELD. JIMS
IS NOT RESPONSIBLE FOR THE QU LITY ND S FETY OF YOUR WORK.
CAUTION:
Wear safety glasses. Excessive force may damage parts and tool.
Note: Please read all instructions completely and thoroughly before performing any work.
Recommended JIMS tools
See JIMS catalog for a complete list of engine tools. Catalog may be viewed at www.jimsusa.com
Other Recommended tools and parts:
• Service manual for the year and model you will repairing.
• Parts book for the year and model you will repairing.
• New bearings
• New retaining rings ( 2003 – 2010 )
• New retaining screws ( 2011 to present )
• Retaining ring remover
• Clean engine oil
• Tools to check bearing bores
Read complete instructions thoroughly before using this tool
Refer to H-D Service Manuals, for the year and model your working
on, to prep engine cases for usage of this tool.

Right Case Bearing Removal: For 2011 to present Alpha Only

engines
1.
Start by removing and discarding 2-case bearing retaining screws from cam chest area
2.
Take support tube No.
facing upward.
3.
Next place the right case with the cam chest side facing downward on the support plate. On the 2011 and
later models you will need to position the No.
locate in the cam chest area to clear the screw mounting boss and sit flush against the bearing.
See Fig 2
555 Dawson Drive, Camarillo, CA 93012 Phone 805-482-6913 • Fax 805-482-7422
Division of Thiessen Products, Inc.
IS NOT RESPONSIBLE FOR D M GE, INJURY, OR YOUR WORK. JIMS
®
1670
and place it on a clean hydraulic press table with the laser marked "A" side of tool
Mounting
screws
Cover screws
mounting
boss
2011 To Present
1670
tool with the small half circle cutout on the top edge to
Rev B
® Research and Development
FIG.1
See Fig 1
9-10
®
1 1