Advertisement
Quick Links
Installation & Operation Manual
Chef Base
(R290)
Please read this manual completely before installing or operating this unit!
BACB36-HC BACB36M-HC
BACB48-HC BACB48M-HC
BACB53-HC BACB53M-HC
BACB72-HC BACB72M-HC
BACB74-HC BACB74M-HC
BACB84-HC BACB84M-HC
BACB86-HC BACB86M-HC
BACB96 -HC BACB96M-HC
Blueair FSE reserves the right to make product modification at any time.
Specifications and Designs are subject to change without notice.
IMPORTANT SAFETY INSTRUCTION (SAVE THESE INSTRUCTIONS)
www.blueairfse.com
Visit our website at
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Blueair BACB36-HC
Summary of Contents for Blueair BACB36-HC
- Page 1 BACB74-HC BACB74M-HC BACB84-HC BACB84M-HC BACB86-HC BACB86M-HC BACB96 -HC BACB96M-HC Blueair FSE reserves the right to make product modification at any time. Specifications and Designs are subject to change without notice. IMPORTANT SAFETY INSTRUCTION (SAVE THESE INSTRUCTIONS) www.blueairfse.com Visit our website at...
- Page 2 ◆ Installing Casters _ _ _ _ _ _ _ _ _ _ _ _ _ _ 7 Service Contack ________________ ______________ Blueair FSE has a Nationwide Service Network To provide timely service to our customer’s needs. Please call or fax us at the following numbers. Blueair FSE Nationwide Sevice Network...
- Page 3 Product Chef Bases BACB36 BACB48 BACB53 BACB72 BACB74 BACB84 BACB86 BACB96 Model M-HC M-HC M-HC M-HC M-HC M-HC M-HC M-HC Capacity (cu.ft) 14.3 14.3 17.2 17.2 21.4 36” 48” 53” 72 ” ” 84” ” ” Exterior Dimensions ” (including casters) (H)* ”...
-
Page 4: Installing Casters
1. INDOOR USE ONLY 1) This unit is intended for indoor use only. 2. FOR LOCATION 1) Be sure that the location is strong enough to support the total weights of unit and the content. 2) Keep the unit away from sunlight and other heat generating equipment. 3) The minimum clearance between the back of the unit and wall should be 7 inches at least 3. - Page 5 1. The temperature controller (thermostat) is located on the upper left of the back side of the cabinet interior. 2. The controller has been preset “NORMAL” position at the factory. 3. Set the control knob toward “COOL” for higher temperature and “COLD” for lower temperature.
- Page 6 Problem Possible Solutions · Check the power cord and make sure it is plugged in. Compressor Failure to · Check the temperature controller. If it is in the “OFF” Start position, turn it clockwise to set a desired temperature. · Move the unit from direct sunlight. ·...
- Page 7 1. Remove the outer packing. 2. Install the casters in the area. 3. Maker sure that castors with brakes should be installed in front.
-
Page 9: Warranty Registration Card
口 Yes, I would like the extended warranty. / 口 No, I would not like the extended warranty. Signature of Business Owner:______________________________ Date:_____________________ ※ The Warranty becomes void if the attached warranty card is not filled out and returned to Blueair within 12 days from the purchase date. Cut along dotted line and mail it back to Blueair Customer Service Dept. - Page 10 Blueair FSE, LLC 223 W. Rosecrans Ave. Gardena, CA 90248 Toll Free, 1-866-677-8500 TEL, (310) 808-0102 FAX, (310) 808-0242 Visit our website at www.blueairfse.com...
Need help?
Do you have a question about the BACB36-HC and is the answer not in the manual?
Questions and answers