Page 1
INSTALLATION INSTRUCTIONS FOR THE CADDY ADVANCED FURNACE BLOWER BOX PA08585/PA08586 This manual is available for free download on the manufacturer’s web site. It is a copyrighted document. Re-sale is strictly prohibited. The manufacturer may update this manual from time to time and cannot be responsible for problems, injuries, or damages arising out of the use of information contained in any manual obtained from unauthorized sources.
Page 2
For installation instructions of the other components of the furnace (temperature sensor, servomotor, electronic boards) as well as electrical diagrams for the wood- electric or wood-oil combination furnace refer to the Caddy Advanced furnace user’s manual. CONTENT OF THE BOX (PA08585 & PA08586) CARDBOARD AIR FILTER 25"...
Page 4
1 BLOWER BOX ASSEMBLY INSTRUCTIONS Step 1 Unscrew the screws (C) and keep them. Dispose of the part (A).
Page 5
Step 2 Take 3 screws (B), kept in the previous step, and reinstall them as the picture below.
Page 6
Step 3 Unscrew the screws (C) used to secure the electronic board cover plate (E) and the protective housing (D) and of the furnace as shown. Keep all parts from this step.
Page 7
Step 4 Unscrew the screws (H) of parts G and F. Remove them and keep them.
Page 8
Step 5 Install the leveling bolts (J). Put the blower box in place. Using the screws (H) contained in the instruction manual kit, secure the box in place.
Page 9
Step 6 Using the screws (B), kept in step 1, finish fixing the blower box. Take the blower wire and pass it through the grommet (J) contained in the manual kit.
Page 10
Step 7 Install the blower wire in the grommet (K). Pull the excess wire to secure with the Ty-Rap (L) provided in the manual kit.
Page 11
Caution! The following steps apply only to the connection of the ECM motor. Step 8 Remove part (N) to install the grommet (K).
Page 12
Step 9 Take the black wire coming from the blower and connect the wire (O) contained in the manual kit and pass it through the 2 grommets; one from the blower box and one from the electronic card box. ...
Page 13
Step 10 Disconnect the black wire from the electronic board and connect the wire from the blower. Take the unplugged wire from the power cord and connect it to the wire coming from the blower.
Page 14
2 DUCT SUPPORT INSTALLATION You can install the duct support on the TOP, RIGHT or LEFT side of the blower box. IMPORTANT! If you decide to install the assembled duct support on top of the blower box, you will need to purchase and install the top air return plenum option PA08506, sold separately.
Page 15
Next, install the top air return plenum option PA08506 (M). Assembly instructions for the plenum are included with the kit, sold separately.
Page 16
2.2 RIGHT side installation Secure the right blower housing side panel (G) to the top of the blower housing with the screws (H) provided. Secure the left blower housing side panel (G) to the left side of the blower housing with the screws (H) provided. Then secure the duct support assembly (F) to the right side of the blower housing with the screws (F).
Page 17
LEFT side installation Secure the left blower housing side panel (G) to the top of the blower housing with the screws (H) provided. Secure the right blower housing side panel (G) to the right side of the blower housing with the screws (H) provided. Then secure the duct support assembly (F) to the left side of the blower housing with the screws (F).
Page 18
REGULAR MOTOR ELECTRICAL WIRING DIAGRAM...