Advertisement
4.2.
INSTALL WHEELS (ROLLCABS) (REFER TO FIG.2)
4.2.1.
Carefully lay rollcab on its back, with a soft mat underneath for protection. Install the two braked casters on the same end as the
handle.
4.2.2.
Insert the carriage bolts through washers, then through the casters and into the bottom of the cabinet. Tighten securely.
4.2.3.
Install the fixed wheels on the opposite end to the handle.
fig.2
4.4.
REMOVE DRAWERS (REFER TO FIG.3)
4.1.1.
Pull drawer out until almost fully extended. Push up one black release lever, while pulling down the other hand black release lever.
4.1.2.
Whilst holding the levers in these positions pull the drawer out until it is released from the drawer slide.
4.5.
REPLACE DRAWERS
4.5.1.
Extend the drawer slides from the tool chest/cabinet.
4.5.2.
Insert the brackets on each side of the drawer into the slots in the chest/cabinet slides, being careful that they are properly positioned.
4.2.4.
Once properly inserted, completely close the drawer to set the slides in their proper positions.
4.3.
RAISE AND RELEASE DRAWER HANDLES (REFER TO FIG.4)
4.6.1.
These units are equipped with raise and release drawer handles.
4.6.2.
To open, lift up the drawer handle, whilst pulling it towards you. To close, shut the drawer firmly, until the latch engages.
4.6.3.
If the drawer does not stay closed, the hook may be bent or it may rub against the drawer slides. To fix lightly bend the hook until the
drawer will engage in the slide.
4.7.
CHEST AND CABINET CONNECTION (REFER TO FIG.5)
4.7.1.
Place the chest on the rollcab.
4.7.2.
Attach the connectors, as shown, to both ends. Ensure that the clip fully engages in the back of the topchest.
fig.4
5. MAINTENANCE
5.1. Lubricate the wheels annually with bearing grease.
5.2. Lubricate the drawer slides twice a year.
5.3. Periodically, the drawer fronts, drawer trim and other surfaces should be cleaned with mild detergent and water.
ENVIRONMENT PROTECTION
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to
a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely
unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids
according to local regulations.
.
Note: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior
notice.
Important: No Liability is accepted for incorrect use of this product.
Warranty: Guarantee is 12 months from purchase date, proof of which is required for any claim.
Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR
01284 757500
© Jack Sealey Limited
01284 703534
sales@sealey.co.uk
Original Language Version
fig.3
fig.5
www.sealey.co.uk
PTB104008, PTB105511 Issue:4 (2) 12/05/21
Advertisement
