General safety instructions............... 10 Contents 7.2 Installation according to EN1717 ............10 1. Safety Guidelines ................3 7.3 Inspection before assembly ............. 11 1.1 Safety instructions in this manual............3 7.3.1 Installation site 11 1.2 Safety instructions in the system............3 7.4 Installing the compact booster unit ...........
1. Safety Guidelines 1.3 General safety instructions This manual contains basic instructions which are to be observed in trans- 1.1 Safety instructions in this manual port, assembly, start-up, operation, maintenance, shut-down, storage and waste disposal. Danger The following safety instructions have to be observed while operating the Places with this sign signify that death, severe bodily injury or significant compact booster unit: property damage will occur if the appropriate precautionary measures...
1.7.1 Mechanical residual dangers During normal operation, no danger is threatened from mechanical components. 1.7.2 Residual dangers pertaining to fluids During normal operation, no danger is threatened by hydraulic components. Hazards might result solely under the following conditions. Danger area Type of hazard Reduction of hazard Pipelines...
For safety reasons, no unauthorised modifications may be made to the compact booster unit. • Keep unauthorised persons (e.g. children) away from the system. Parts and special equipment not delivered by Resideo are also not autho- 1.12 Requirements for operating personnel rised by Resideo for use.
In order to maintain the warranty, in the event of damage immediately Instructions for the pressure sensor contact the nearest Resideo service centre. Instructions for the throttle valve 2.1 Conformity with the following norms Instructions for the membrane pressure vessel ...
3. Description 3.1.1 Installation type • Fixed installation Speed controlled compact booster unit with a vertical high-pressure pump as a safety device to separate potable water from category 5 fluids according to 3.2 Intended use EN 1717 . The compact booster unit may only be operated in such areas as described Fully automatic, fully wired Compact Booster Unit with modular design in the other applicable documents.
4. Function 3.4 Version Speed-controlled compact booster unit with: 4.1 Inlet side • 1 normal sucking, vertical high-pressure rotary pump with all components On the inlet side there is a buffer tank. It has a floating valve on its inlet to in contact with the medium made of stainless steel refill water.
2. In the case of transport damage estimate the extent, document the Danger for persons, near-by systems and the the environment that damage and notify Resideo immediately in writing. arises from the non-intented use of the compact booster unit.
7.3 Inspection before assembly 7.6 Buffer tank 7.3.1 Installation site Caution Sufficient noise insulation for the building is ensured due the compact Dirt in the system booster unit`s safety store. Damage to the pumps! The system has to be installed above the flood level. Provide a suitable Rinse the tank before filling it.
8. Start-up 8.3 Initial operation The initial start-up should be performed by Resideo technical staff. Performance of tasks only by qualified personnel (see section 1.12). Caution The pipeline must be free of residue 8.1 Safety instructions for start-up Danger of damaging the pump/compact booster unit! ...
2. Rinse the tank and the integrated odour trap regularly. Maintenance should be performed by Resideo technical staff. 3. Check if the overflow is sealed and clean. • If necessary contact the service department at Resideo. Monitoring Operation 10.2.2 Performance of tasks only by qualified personnel (see section 1.12).
2. Secure the system against unintentional operation 10.3 Maintenance Empty the compact booster unit if it is shut down for a longer period of Maintenance should be performed by Resideo technical staff. time. 12.2 Restarting the compact booster unit Alterations or modifications of the system are only permitted with the Please note the procedures in chapter 8.
14. Disassembly, disposal 14.1 Safety instructions for disassembly Danger through improper disassembly Performance of tasks only by qualified personnel (see section Danger 1.12). Unintentionally switching on the compact booster unit It is imperative to observe the laws and regulations on waste disposal Danger to life! ...
16. Start-up protocol The following so-called Resideo Compact Booster Unit was commisioned today by the signatories, authorised Resideo customer service staff, and this protocol was written. 1 Compact booster unit Series ..................Size ..................Serial number ..................Order number ..................
17. Declaration of no objection Type Order number/Order item number ................................. Delivery date ................................. Range of application ................................. Pumped medium ................................. Make a check mark if applicable radioactive explosive corrosive poisonous hazardous to health biohazard flammable harmless...
18. Proof of Maintenance Resideo 74821 Mosbach Germany Compact booster unit According to normative requirements for potable water, this central booster unit requires frequent maintenace contucted by enabled personal, which needs to be documented after compleshion. This compact booster unit is subject to the standards for potable water and guidelines for maintenance therein, and have to be maintained regularly by qualified personnel and the results have to be documented.
Page 19
Ademco 1 GmbH @2020 Resideo Technologies, Inc. Hardhofweg 40 All rights reserved. 74821 Mosbach This product is manufactured by Phone: +49 1801 466 388 Resideo Technologies, Inc and its info.de@resideo.com affiliates. www.resideo.com homecomfort.resideo.com MU1H-1376GE23 R1020 - Translation of original...
Need help?
Do you have a question about the Braukmann CBU146 and is the answer not in the manual?
Questions and answers