Hanna Instruments HI10482/HALO Quick Start Instruction Manual

Thank you for selecting a Hanna Instruments product. Please read this manual before using the Halo
probe on your iPad® with Hanna Lab App or with edge® blu. Consult the Hanna Lab App "HELP" or the
edge blue instruction manual for additional information on Probe Maintenance and calibration.
IMPORTANT! During servicing and measurement,
surface. It will permanently damage the probe.
to protect and keep the pH bulb hydrated.

PREPARATION:

Remove the probe from the plastic storage tube by unscrewing
the top collar to vent the cap before removing. Save cap and
collar for probe storage.
1. Rinse off any storage solution or salts that may be on the
glass body.
2. Remove the fill hole cap and top off electrolyte reservoir
with HI 7082 if required. It is best to operate the probe
with fill hole open to ensure electrolyte flow through the
junction.
3. Check to verify there is solution inside the pH bulb,
shaking the probe down can restore continuity as the
solution may have moved up the stem during shipping.

CONNECTION:

Using Hanna Lab App on an iPad®
To begin using the HALO™ probe, start the Hanna Lab
1.
app and tap the Bluetooth icon on the iPad®.
2. Press the operation button located on the top of the probe.
The blue LED halo will begin to flash in half second
intervals, indicating it's in discoverable mode and the
probe ID will appear in the list of probes.
3. Touch the probe ID once it appears in the list of probes.
The blue LED will slow down and flash every 2 seconds.
Using Edge®blu
To begin using the HALO™ probe, turn ON edge®blu.
1.
The meter swill start scanning for probes.
2. Press the operation button located on the top of the probe. The blue LED halo begin to flash in half
second intervals, indicating it's in discoverable mode and the probe ID will appear in the list of probes.
3. Select your probe in the list of visible probes and press CFM. The blue LED will start flashing 4 times
a second while connecting, then it will slow down and flash every 2 seconds showing it is connected
and ready to measure.
MEASUREMENT SETUP:
1. Calibrate the pH probe.
2. Take measurements using the pH probe.
HI10482/HALO pH PROBE
QUICK START INSTRUCTION GUIDE
During storage or transport, utilize the clear protective cap
handle probe with care. Do not drop probe on a hard
Blue HALO Indicator
Operation Button
Hole
Movable PTFE Sleeve,
Open Junction
Domed pH Sensitive Bulb