Zone Remote Panel Installation Operations - Immergas 3.030863 Instructions And Warnings

1.2

Zone Remote Panel installation operations.

1) Separate the fixing template from the body of the Zone
Remote Panel using a screwdriver as a lever in the relative
recess (Fig. 2). Install the Zone Remote Panel away from
heat sources and in a suitable position to detect the room
temperature correctly.
2) Install the Zone Remote Panel using the openings on its
rear part directly onto the wall or on a recess box using
the relative supplied screws.
3) Connect the Zone Remote Panel to the electronic
management clamps, as indicated in the wiring diagram.
The connection is made using wires with a minimum section
of 0.50 mm and maximum section of 1.5 mm
2
maximum length of 50 metres.
N.B: for correct installation, prepare a dedicated line to
connect the Zone Remote Panel according to the Standards
in force regarding electrical systems. If this is not possible,
interference due to other electric cables could cause mal-
functioning of the Zone Remote Panel itself.
4) Fix the body of the Zone Remote Panel to the mount
template, engaging it with pressure.
5) After the device has been powered, wait about 30 seconds
before regulation so that communication between Zone
Remote Panel and the device has established.
28
and with a
2