Installation - Schon 67522-5201 Use And Care Manual

Installation

1
Preparing for installation
CAUTION: Always turn off the water supply before
removing an existing faucet or replacing any part of a
faucet. Open the faucet handle to relieve water pressure
and ensure that the water is completely shut off.
□
Shut off the water supply. Remove the old faucet.
Clean the surface in preparation for the new
faucet. Drill a hole min 57mm diameter-max
65mm diameter in the oor.
□
Loosen the set screw (B) pre-assembled to the
spout (A), rotate the spout (A) about 90
the spout (A) towards the front, then tighten the
screw (B).
A
2
Installing the escutcheon
□
Place the escutcheon (E) over the standpipe (D)
and then push it to the base.
to make
0
A
B
4
E
D